Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

Influence of impeller and guide vane hub size on hydraulic performance of mixed-flow pump

The Optimization of A Low Specific Speed Pipeline Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Mixed-flow pump performance improvement based on circulation method

Effect of Trailing-Edge Modification of A Mixed-Flow Pump

Effects of Meridional Flow Passage Shape on Hydraulic Performance of Mixed-flow Pump Impellers

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

Analysis of key parameters for mixed-flow pump impeller design

Influence of blade leading-edge form on the performance and internal flow pattern of a mixed-flow pump

Experimental Study of the Effect of Blade Tip Clearance and Blade Angle Error on the Performance of Mixed-Flow Pump

High-efficiency design of a mixed-flow pump using a surrogate model

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Computational Fluid Dynamics-Based Pump Redesign to Improve Efficiency and Decrease Unsteady Radial Forces

Multi-parameter Optimization Design, Numerical Simulation and Performance Test of Mixed-Flow Pump Impeller

Numerical simulation and model test of the influence of guide vane angle on the performance of axial flow pump

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Multi-objective optimization of a high efficiency and suction performance for mixed-flow pump impeller

Influence of Blade Wrap Angle on Centrifugal Pump Performance by Numerical and Experimental Study

Numerical Investigation on Hydraulic Performance at Low Flow Rates of a Mixed-flow Pump with Impeller Inlet Diameter Effects

Numerical investigations on performance improvement mechanism of a high-power vertical centrifugal pump with special emphasis on hydraulic component matching

Experimental study on hydraulic performance optimization of ultra-low specific speed centrifugal pump