Abstract:Ultrafiltration hollow-fiber membranes were prepared from polyetherimide (PEI) with a wet spinning method. The effects of N,N-dimethylacetantide (DMAc) as a solvent additive in the internal coagulant and acetic acid as a non-solvent additive in the dope solution on the morphologies and performances of the membranes were investigated. The influences of PEI dope concentration on membrane morphologies and properties were also studied. Scanning electron microscopy (SEM) indicates that the addition of DMAc into the internal coagulant changes the inner fiber surface from a dense skin layer to a porous structure. However, the pure water flux of the membrane decreases with the increase of DMAc content. On the other hand, the addition of acetic acid into the casting solution promotes the spinodal demixing of the membratte-forming system and suppresses the macrovoid formation in the membrane. A nodular structure forms in the fiber skin layer. With increasing acetic acid content, the pure water flux of the membrane increases about 4-fold and the solute retention shows a slight decrease. The mechanical properties can also be improved slightly by this additive. The thermal resistance of the PEI ultrafiltration membranes prepared in this work was examined by hot water treatment at 80 degrees C. No change was observed in the permeation performance of the membranes, while the study of mechanical properties shows that the elongation-at-break of the membrane decreases slightly. PEI was sulfonated by chlorosulfonic acid (CSA) in 1,2-dichloroethane. With the increase of the molar ratio of CSA to PEI repeat unit and/or reaction time, the ion-exchange capacity (IEC) of the sulfonated polyetherimide (SPEI) increases accordingly. Water uptake test and contact angle measurements show that the hydrophillicity of the SPEI increases with the increase of the IEC. Polyetherimide/sulfonated polyetherintide (PEI/SPET) ultrafiltration hollow-fiber membranes were also prepared with a dry-wet phase inversion method and SPEI was used as a polymer additive. SEM study reveals that the addition of SPEI induces the formation of nodular structure and suppresses the formation of finger-like macrovoids. With the increase of air-gap distance, it was found that the number of micropores formed in the outer fiber surface and the pore size increased. On the other hand, the pure water flux of the membrane reaches a maximum and then decreases, while the solute retention decreases at first and then levels off at longer air-gap. Based on the filtration of bovine serum albuntin (BSA) solution, it was found that the use of SPEI in the blend membranes increased their hydrophilicity.

Modification of polyethersulfone membranes by Polyethyleneimine (PEI) grafted Silica nanoparticles and their application for textile wastewater treatment

Tailoring the Selectivity of Quasi-Pims Nanofiltration Membrane Via Molecular Flexibility of Acyl Chloride Monomers for Desalination from Dye Effluents

Novel ZnO-Modified Polyethersulfone Nanocomposite Membranes for Nanofiltration of Concentrated Textile Wastewater

High-performance loose nanofiltration membrane prepared with assembly of covalently cross-linked polyethyleneimine-based polyelectrolytes for textile wastewater treatment

Polyethylenimine-mica nanosheets/cellulose nanofibers stacked loose nanofiltration membrane for effective dye/salt separation

Dye sieving and dye/salt separation PEI-based loose nanofiltration membrane modified by NH 2 -MIL-101(Fe) and polyphenol coating

Polyetherimide thin film composite (PEI-TFC) membranes for nanofiltration treatment of dyes wastewater

Monitoring the decolourisation efficacy of advanced membrane fabricated phytosilica nanoparticles in textile effluent water treatment

Development of antifouling nanofiltration membranes for separation of dye/salt mixture through incorporation of novel polyelectrolyte-decorated silica

Study on the properties of a nanofiltration membrane with O-MoS2 nanocomposite substrate and the applications in dye wastewater treatment

Designing durable self-cleaning nanofiltration membranes via sol-gel assisted interfacial polymerization for textile wastewater treatment

Preparation of a CPVC composite loose nanofiltration membrane based on plant polyphenols for effective dye wastewater treatment

A novel synergistic effect of TiO2 and ZnO incorporation in PES-based thin-film nanocomposite nanofiltration membrane for treatment of textile wastewater

Synergistic contribution of sulfonated poly(ether sulfone) and iminodiacetic acid functionalized-graphene oxide nanosheets towards enhancing cationic dye wastewater purification using nanocomposite membranes

Nanocomposite Deposited Membrane for Oil-in-Water Emulsion Separation with in Situ Removal of Anionic Dyes and Surfactants

Treatment of Dye Aqueous Solutions Using A Novel Aromatic Polyamide Asymmetric Nanofiltration Membrane

Loose nanofiltration membrane with highly-branched SPEI/PEI assembly for dye/salt textile wastewater treatment

Perfluoro-functionalized polyethyleneimine that enhances antifouling property of nanofiltration membranes

Fabrication and performance evaluation of an innovative asymmetric polyethersulfone composite membrane for efficient methyl blue filtration

Preparation And Performance Of Ultrafiltration Membranes From Polyetherimide And Its Sulfonated Derivatives

Highly antifouling polymer-nanoparticle-nanoparticle/polymer hybrid membranes