Abstract:A novel micromachining technology for multilevel structures of silicon is described in this paper. Complicated multilevel structures can be formed by using a maskless etching following a conventional masked etching in aqueous KOH. The process consists of two successive steps. First, structures with (111) sidewalls are formed for a desired etching depth on the surface of a (100) silicon wafer by a conventional masked anisotropic etching process with a specially designed etching mask. Then, the etching mask is removed except for some areas (such as the frame of the chip) and a maskless etching follows. In addition to the downward etching of the upper and lower (100) planes during maskless etching, fast-etching (311) planes emerge at the upper edges of the (111) sidewalls and cut the (111) sidewalls, while the (111) sidewalls extend downward at the lower ends. As the (311) planes replace the (111) sidewalls with a rate faster than the extension rate of the (111) planes, the (111) sidewalls will finally be replaced by (311) planes. Moreover, by an appropriate mask design and an appropriate etching depth of the previous masked etching, the bottom areas of some etching cavities diminish temporarily so that the downward etching in these areas is stopped for time intervals after the intersection of (111) planes on the bottom and before the (111) planes are replaced completely by the (311) planes. Once the (111) sidewalls are replaced completely by the (311) planes, the bottom areas reappear and the etching downward resumes. Analyses show that levels with different depths can be created in this way for different window apertures and the number, positions as well as the depths of the new levels can be individually decided by the design of the single mask for masked etching and the etch depths of both masked and maskless etching processes. More than 10 interesting multilevel structures with up to five structure levels have been fabricated. The results show that the technology is very versatile and repeatable. Therefore, this technology is a very useful new tool for making silicon micromechanical structures to meet the ever-increasing demands for solid-state sensors and actuators. (C) 1997 Elsevier Science S.A.

New silicon hard mask material development for sub-5nm node

Investigation of Amorphous Silicon As Dry Etch Hard Mask in BEOL Low-k Dielectric Patterning

A spin-on photosensitive polymeric etch protection mask for anisotropic wet etching of silicon

Silicon Containing Organic-Inorganic Hybrid Materials As Euv Photoresists

Improved PECVD SixNy film as a mask layer for deep wet etching of the silicon

28nm Metal Hard Mask etch process development

Wet Scandium Etching for hard mask formation on a silicon substrate

Silicon Backbone Polymers As EUV Resists

Development of a facile block copolymer method for creating hard mask patterns integrated into semiconductor manufacturing

Resistless EUV lithography: photon-induced oxide patterning on silicon

Total Solutions for 40nm Metal Hard-Mask All-In-One Etch Process

Polymeric mask protection for alternative KOH silicon wet etching

Materials for Future Lithography (invited Paper)

High molecular weight block copolymer lithography for nanofabrication of hard mask and photonic nanostructures

Towards 11nm Half-Pitch Resolution for a Negative-Tone Chemically Amplified Molecular Resist Platform for Extreme-Ultraviolet Lithography

Low-temperature plasma etching of high aspect-ratio densely packed 15 to sub-10 nm silicon features derived from PS-PDMS block copolymer patterns

A route to engineered high aspect-ratio silicon nanostructures through regenerative secondary mask lithography

A novel micromachining technology for multilevel structures of silicon

Inorganic Polymer Resists for EUVL

A New Release Process in Surface Micromachining-Double Mask Technology

Novel Silicon-Containing Polymers As Photoresist Materials for EUV Lithography