Treatment efficiency and recovery in sand filters for on-site wastewater treatment: Column studies and reactive modelling
Rajabu Hamisi,Agnieszka Renman,Gunno Renman,Anders Wörman,Roger Thunvik
DOI: https://doi.org/10.1016/j.jclepro.2024.142696
IF: 11.1
2024-05-31
Journal of Cleaner Production
Abstract:This study examined the adsorption capacity and treatment efficiency of sand filters in on-site treatment systems for cold climate regions. The effects of different operating conditions, porosity and kinetics parameters were investigated in column experiments and COMSOL Multiphysics® modelling, to comprehensively reveal the mechanisms and optimize treatment efficiency of nitrogen (N) and phosphorus (P) removal in a field tidal flow constructed wetland (TFCW), treating effluent from a package treatment plant with P filter material. The results from column experiments with sand showed that Total-P adsorption rate was dependent on feed water quality (Septic tank >0.77 ± 0.06 g kg -1 ; Biotreatment >0.41 ± 0.07 g kg -1 ; Reactive material Polonite® <0.18 ± 0.07 g kg -1 ). In the field TFCW trial, Total-P adsorption in the top layer (>1.42 ± 0.55 g/kg) and middle layer (>1.06 ± 0.51 g/kg) was twice that in laboratory columns, due to strong interaction with the air-water interface and use of fluctuated domestic wastewater solutions. The breakthrough curve (BTCs) of the coarse sand matched the physical behaviour of tracer electrical conductivity (EC) in effluent from the sand column experiments. The modelling results demonstrated that high filter porosity and low hydraulic load were significant factors for optimal removal of NH 4 -N, Total-N, PO 4 -P, Total- P in the top layer (>99.95 ± 0.03 %, 44.37 ± 28.75%, 70.89 ± 28.30%, 76.18 ± 20.3%), middle layer (>98.94 ± 1.77%, 18.23 ± 23.04%, 76.62 ± 28.73%, 65.40 ± 31.85%) and deep layer (>99.99 ± 0.02%, 65.50 ± 20.64%, 75.53 ± 23.16%, 41.54 ± 28.81%) in the TFCW system, respectively. The results show that on-site wastewater treatment in cold climate TFCW can be applied as a technology to polish effluent from a three-step pretreatment system. However, hydraulic optimization is an important factor for the design of the TFCW to receive a successful long-term operating system.
environmental sciences,green & sustainable science & technology,engineering, environmental