Abstract:Safe drinking water requires sound monitoring and maintenance of residual chlorine within drinking water distribution networks (DWDNs) to suppress possible microbial regrowth. However, in the developing world, DWDNs face unique challenges, including aging infrastructure, water pipes laid near or even aboveground thus exposing water to high temperature fluctuations, and relatively high organic loads. Therefore, safely maintaining sustainable residual chlorine levels and restricting the problems of hazardous disinfection by-products (DBPs) formation and of antimicrobial resistance (AMR), both tracing back to extensive chlorination, is a difficult exercise in those settings. Here, the temperature dependent bulk chlorine decay, i.e., the rate at which chlorine residual is consumed, was estimated for a typical DWDN system in South Africa. To this end, experimental assays were performed and a mathematical model was developed to predict chlorine levels within the DWDN under study. A direct relationship (R2 = 0.99) between bulk chlorine decay and initial chlorine dosage was identified, with bulk chlorine decay following the first-order decay model. The bulk chlorine decay rate coefficient (Kb) and the reaction constant with the pipe walls (Kw) were experimentally estimated, with the first being the main chlorine consumer and the latter only slightly contributing to chlorine decay. EPANET was used to simulate the chlorine concentrations within the examined DWDN, while residual chlorine concentrations were modelled using COMSOL. The software programs were calibrated and validated using experimental results. The optimum liquid chlorine dosage was 5 mg L-1, and this could maintain residual levels at 0.5 mg L-1 for 3500 min in the water distribution tanks. Yet, the residual chlorine levels at the distal end of the DWDN were below the recommended safety limits, suggesting the need for chlorine booster stations to supplement residual chlorine rather than further increasing chlorine initial dosages which will lead to unsafe chlorine levels at the proximal points and inevitably will increase DBPs in drinking water. This relatively high chlorine dosage reflects the overall poor quality of the raw water that feeds the drinking water treatment plant under study, which is consistent with the poor water quality of surface water in South Africa. Overall, this methodology can be replicated in DWDNs in South Africa and across the developing world, where similar challenges persist and ensure safe drinking water but not at the expense of DBPs formation and possibly AMR spreading.

A Comparative Study on a Hydraulic and Water-Quality Analysis Method for Determining Rechlorination Injection Points for a Water-Supply Network

Optimization analysis for influence of water quality monitoring station on booster chlorination in water distribution system

Homologous coverage based stable control of chlorine concentration in water distribution systems

Optimal Analysis of Improved Water Quality Performance and Rechlorination Cost

Optimal Operation of Residual Chlorine Concentration in Multi-Source Water Distribution System

Water Quality Reliability Analysis of Booster Chlorination in Water Distribution Networks

Optimal scheduling and analysis of booster chlorination in water distribution network based on desired chlorine residual mass concentration

Demand-Driven Spatiotemporal Variations of Flow Hydraulics and Water Age by Comparative Modeling Analysis of Distribution Network

Joint Majorization of Waterworks and Secondary Chlorination Points Considering the Chloric Odor and Economic Investment in the DWDS Using Machine Learning and Optimization Algorithms.

A Novel Statistical Model for Water Age Estimation in Water Distribution Networks

Application of decision making model for leakage reduction to economic project in water distribution systems

Developing a Methodology to Establish Response Zones based on Travel Time for Controlling the Spread of Water Quality Incidents in Water Supply Systems

Decision Support Framework for Optimal Reservoir Operation to Mitigate Cyanobacterial Blooms in Rivers

Assessment of Groundwater Recharge in Agro-Urban Watersheds Using Integrated SWAT-MODFLOW Model

Development and Application of a Chlorine Disinfection Model for a Conventional Waterworks

Optimization and Assessment of Residual Chlorine using Response Surface Methodology (RSM) and Artificial Neural Network (ANN) Modeling

Quantifying Chlorine-Reactive Substances to Establish a Chlorine Decay Model of Reclaimed Water Using Chemical Chlorine Demands

The insightful water quality analysis and predictive model establishment via machine learning in dual-source drinking water distribution system

Experimental appraisal and numerical modelling of chlorine demand and decay in a typical drinking water distribution network in South Africa

Models for predicting carbonaceous disinfection by-products formation in drinking water treatment plants: a case study of South Korea

Quantitative Models and Potential Surrogates for Rapid Evaluation and Surveillance of Chlorine Disinfection Efficacy in Reclaimed Water.