Effect of the Particle-Size Distribution on the Electrochemical Performance of a Red Phosphorus–Carbon Composite Anode for Sodium-Ion Batteries

Isaac Capone,Kevin Hurlbutt,Andrew J. Naylor,Albert W. Xiao,Mauro Pasta
DOI: https://doi.org/10.1021/acs.energyfuels.9b00385
2019-04-09
Abstract:Red phosphorus (RP) is a promising candidate as an anode for sodium-ion batteries because of its low potential and high specific capacity. It has two main disadvantages. First, it experiences 490% volumetric expansion during sodiation, which leads to particle pulverization and substantial reduction of the cycle life. Second, it has an extremely low electronic conductivity of 10<sup>–14</sup> S cm<sup>–1</sup>. Both issues can be addressed by ball milling RP with a carbon matrix to form a composite of electronically conductive carbon and small RP particles, less susceptible to pulverization. Through this procedure, however, the resulting particle-size distribution of the RP particles is difficult to determine because of the presence of the carbon particles. Here, we quantify the relationship between the RP particle-size distribution and its cycle life for the first time by separating the ball-milling process into two steps. The RP is first wet-milled to reduce the particle size, and then the particle-size distribution is measured via dynamic light scattering. This is followed by a dry-milling step to produce RP–graphite composites. We found that wet milling breaks apart the largest RP particles in the range of 2–10 μm, decreases the Dv90 from 1.85 to 1.26 μm, and significantly increases the cycle life of the RP. Photoelectron spectroscopy and transmission electron microscopy confirm the successful formation of a carbon coating, with longer milling times leading to more uniform carbon coatings. The RP with a Dv90 of 0.79 μm mixed with graphite for 48 h delivered 1354 mA h g<sup>–1</sup> with high coulombic efficiency (&gt;99%) and cyclability (88% capacity retention after 100 cycles). These results are an important step in the development of cyclable, high-capacity anodes for sodium-ion batteries.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?