A performance comparison between lumped, distributed and optical phase locked local oscillator used in the photonic generation of millimeter-wave signals for radio over fiber systems

Zaineb Samoud,Abir Hraghi,Mourad Menif

DOI: https://doi.org/10.1117/12.2522465

2019-04-26

Abstract:Due to the growth of the number of communication devices over the last decades, the millimeter wave (mm-wave) band has been strong interest. In fact, this band offers a massive bandwidth and highest speed. However, in order to obtain the highest receiver sensitivity, it's necessary to generate the millimeter wave signals with low phase noise. In this paper, we propose the photonic generation of mm-wave signals with three methods. The generation is based on an optical frequency comb source (OFCS) from which five carriers are selected for 40 Gb/s Differential Quadrature Phase Shift Keying (DQPSK) modulation. At the level of the photo-detector, the optical local oscillator (LO) beats the mm-wave modulated signal. In the first case, the optical LO is distributed and emitted from an independent laser. In the second case, the optical LO which is a comb line is lumped. Finally, the optical LO is in an Optical Phase Locked Loop (OPLL) with the OFCS. Furthermore, we compare the performance of the 40 Gb/s DQPSK mm-wave generation and transmission system in the band of 200 - 300 GHz. We discuss their back-to-back (b-to-b) and over 10 km Single Mode Fiber (SMF) in term of Bit Error Rate (BER), Quality factor (Q factor), Signal to Noise Ratio (SNR) for single channel and for multiband channels in the band of 200 - 300 GHz. The system using the phase locked LO source has the high receiver sensitivity since the OPLL assured his phase stabilization. The 250 GHz channel has the best results for single band and multiband generation.