Abstract:Abstract This paper aims at better understanding nanosecond sliding discharges based on a three-electrode geometry and at studying the effect of the shape of the pulsed high-voltage electrode on their electrical, optical and mechanical properties. Three different electrode shapes are considered: a typical planar electrode with a straight edge, a planar electrode with a sawtooth edge, and a wire electrode. First, we verified that the sliding discharge starts to appear when the potential difference between both air-exposed electrodes exceeds about 25 kV, corresponding to a mean electric strength (potential difference divided by the gap) a little bit higher than 6 kV cm −1 , but this value differs slightly depending on the shape of the electrode. Secondly, we highlighted that the current with the wire-based discharge is slightly higher compared to the two others because the streamers are more numerous and they are more uniformly distributed along the wire. Moreover, whatever the electrode shape, intensified charge-coupled device visualizations showed that many streamers initiate from the pulsed high-voltage electrode edge and propagate on the dielectric surface toward the DC voltage electrode at a mean velocity of about 1 mm ns −1 . However, the streamer trajectory depends strongly on the electrode shape. Visualizations of the pressure waves induced by the different plasma actuators have been realized with a shadowgraph system. In the presence of a sliding discharge, every streamer is at the origin of three different pressure waves. The first hemispherical pressure wave results from streamer ignition at the edge of the pulsed high-voltage electrode, the head of the streamer acting as a point heat source. The second hemispherical pressure wave is due to the corona-type discharge that ignites from the negative DC high-voltage electrode when the streamer head gets closer. Finally, the third wave is a semi-cylindrical wave as each streamer acts as a line source of heat. To conclude, pressure measurements highlighted that the peak value of the pressure is nearly constant along the spanwise direction of the wire electrode as it presents high fluctuations with the sawtooth electrode, the maximum pressure being measured above the tips, where streamers are localized.

Filamentary nanosecond surface dielectric barrier discharge. Plasma properties in the filaments

Filamentary Surface Plasma Discharge Flow Length and Time Scales

Properties and characteristics of the nanosecond discharge developing at the water-air interface: tracking evolution from a diffused streamer to a spark filament

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Streamer propagation dynamics in a nanosecondpulsed surface dielectric barrier discharge in He/N2mixtures

Three-electrode surface dielectric barrier discharge driven by repetitive pulses: streamer dynamic evolution and discharge mode transition

Filament Formation Mechanism for a Nanosecond Surface Barrier Discharge. Part 2. The Local-Energy Approximation

Numerical simulation of streamer, pressure wave, and vortex induced by nanosecond pulsed surface dielectric barrier discharges

Experimental investigation and 2D fluid simulation of a positive nanosecond discharge in air in contact with liquid at various dielectric permittivity and electrical conductivity

Streamer propagation and pressure waves produced by a nanosecond pulsed surface sliding discharge: effect of the high-voltage electrode shape

Modelling Of Plasma Aerodynamic Actuation Driven By Nanosecond Sdbd Discharge

Nanosecond-pulse dielectric barrier discharge using magnetic compression solid-state pulsed power

Characteristics of Nanosecond-pulse Dielectric Barrier Discharge in Atmospheric Air

Nanosecond Discharge at the Interfaces of Flat and Periodic Ripple Surfaces of Dielectric Window with Air at Varied Pressure

Characteristics of a novel nanosecond DBD microplasma reactor for flow applications

Streamer dynamics and charge self‐erasing of two counter‐propagating plasmas in repetitively pulsed surface dielectric barrier discharge

Experimental and 2D fluid simulation of a streamer discharge in air over a water surface

Characteristics of Radio Frequency Dielectric Barrier Discharge Using Argon Doped with Nitrogen at Atmospheric Pressure

Excitation of Atmospheric Pressure Uniform Dielectric Barrier Discharge Using Repetitive Unipolar Nanosecond-Pulse Generator

Diffuse and Filamentary Discharges in Open Air Driven by Repetitive High-Voltage Nanosecond Pulses

Formation of diffuse and spark discharges between two needle electrodes with the scattering of particles