Abstract:This paper presents the first experimental engine and test rig results obtained from a fast response cooled total pressure probe. The first objective of the probe design was to favor continuous immersion of the probe into the engine to obtain a time series of pressure with a high bandwidth and, therefore, statistically representative average fluctuations at the blade passing frequency. The probe is water cooled by a high pressure cooling system and uses a conventional piezoresistive pressure sensor, which yields, therefore, both time-averaged and time-resolved pressures. The initial design target was to gain the capability of performing measurements at the temperature conditions typically found at high pressure turbine exit (800–1100°C) with a bandwidth of at least 40 kHz and in the long term at combustor exit (2000 K or higher). The probe was first traversed at the turbine exit of a Rolls-Royce Viper turbojet engine at exhaust temperatures around 750°C and absolute pressure of 2.1 bars. The probe was able to resolve the high blade passing frequency (≈23 kHz) and several harmonics of up to 100 kHz. Besides the average total pressure distributions rom the radial traverses, phase-locked averages and random unsteadiness are presented. The probe was also used in a virtual three-hole mode yielding unsteady yaw angle, static pressure, and Mach number. The same probe was used for measurements in a Rolls-Royce intermediate pressure burner rig. Traverses were performed inside the flame tube of a kerosene burner at temperatures above 1600°C. The probe successfully measured the total pressure distribution in the flame tube and typical frequencies of combustion instabilities were identified during rumble conditions. The cooling performance of the probe is compared with estimations at the design stage and found to be in good agreement. The frequency response of the probe is compared with cold shock-tube results and a significant increase in the natural frequency of the line-cavity system formed by the conduction cooled screen in front of the miniature pressure sensor were observed.

Simultaneous Raman and pyrometric temperature measurements in shock-wave-compressed toluene

Measurements of the Principal Hugoniots of Dense Gaseous Deuterium−helium Mixtures: Combined Multi-Channel Optical Pyrometry, Velocity Interferometry, and Streak Optical Pyrometry Measurements

A sub-nanosecond pyrometer with broadband spectral channels for temperature measurement of dynamic compression experiments

In-situ Raman spectroscopy and high-speed photography of a shocked triaminotrinitrobenzene based explosive

Measurement of Multiple Physical Parameters of Dense Gaseous Hydrogen-Deuterium Mixture under Double-Shock Compression: Evaluating Theoretical Models from Multiple Views

A high-speed, eight-wavelength visible light-infrared pyrometer for shock physics experiments

Near-MHz temperature and H2O measurements in post-detonation fireballs of 25 g hemispherical explosives using scanned-wavelength-modulation spectroscopy

Spectroradiometry with sub-microsecond time resolution using multianode photomultiplier tube assemblies

External standard calibration method for high-repetition-rate shock tube kinetic studies with synchrotron-based time-of-flight mass spectrometry

Shock Tube and Multi-Species Laser Absorption Measurements of Rate Constants for Methanol Pyrolysis

In Situ High P-T Raman Spectroscopy and Laser Heating of Carbon Dioxide.

Dynamic and Sensitive Hybrid Fs/ps Vibrational CARS Thermometry Using a Quasi-Common-path Second-Harmonic Bandwidth-Compressed Probe

In situ high pressure-temperature Raman spectroscopy technique with laser-heated diamond anvil cells

Demonstration of Non-Absorbing Interference Rejection Using Wavelength Modulation Spectroscopy in High-Pressure Shock Tubes

Filamentation-based, Two-Beam, 1-Khz, and Single-Shot N2 Vibrational CARS Thermometry in High-Temperature Flames

Raman Spectroscopy of Hot Dense Hydrogen.

Unsteady Pressure Measurements With a Fast Response Cooled Probe in High Temperature Gas Turbine Environments

A diode laser sensor for rapid, sensitive measurements of gas temperature and water vapour concentration at high temperatures and pressures

Measurement of Thermal Diffusivity at High Pressure Using a Transient Heating Technique

H2 chirped-probe-pulse femtosecond coherent anti-Stokes Raman scattering thermometry at high temperature and pressure