Abstract:Heat transfer can be augmented by employing different methodologies and techniques, such as increasing either the heat transfer surface or the heat transfer coefficient between fluid and surface that allows high heat transfer rates in a small volume. The enhanced thermal behavior of nanofluids could supply a basis for a huge innovation in heat transfer intensification. Recently, a new type of nanofluid, known as hybrid nanofluid, which consists of a mixture of two different nanoparticles suspended in the base fluid like water. The present study deals with the analysis of laminar mixed convection heat transfer in horizontal annuli using hybrid nanofluid with the thermal boundary condition of constant heat flux at the inner wall and isothermal outer wall. The SIMPLER numerical algorithm is adopted in the present study. The hybrid nanofluid consists of water as base fluid and Ag-TiO2 as nanoparticles. The ratio of Ag to TiO2 is maintained as 1:3. Main objective of the present study is to compute numerically three-dimensional axis-symmetric, incompressible, steady, laminar flow through annular ducts to investigate the effect of the hybrid nanofluid Ag-TiO2/water on thermal-hydrodynamic characteristics. The analysis reveals that secondary flow due to the buoyancy forces plays an important role in augmenting heat transfer. The development of axial flow and temperature field are strongly found to be influenced by buoyancy. Nusselt number near the entrance region is found to be maximum, then attains a minimum value at a location slightly away from the entrance, and then starts increasing slowly due to the increased buoyancy effects. Finally, the flow becomes almost stable and a nearly constant value of Nusselt number is observed as the flow approaches fully development situation. At a given axial location Nusselt number was found to increase with increasing volumetric concentration of nanoparticle. The effect of Gr Radius ratio on the Nusselt number was also studied

An experimental investigation on heat transfer characteristics of graphite-SiO2/water hybrid nanofluid flow in horizontal tube with various quad-channel twisted tape inserts

Experimental investigation of the effects of graphene nano particle added water fluid on heat transfer in a smooth tube with double inserts

Augmentation of Heat Transfer of High Prandtl Number Fe3O4/vacuum pump oil nanofluids flow in a tube with twisted tape inserts in laminar flow

Property of Water-Nanoparticle Flow and Heat Transfer in the Double-Tube Heat Exchanger with Nanofluid

Heat transfer assessment of turbulent nanofluid flow in a circular pipe fitted with elliptical-cut twisted tape inserts

Internal Flow Analysis of a Heat Transfer Enhanced Tube with a Segmented Twisted Tape Insert

Darcy-Forchheimer hybrid nanofluid flow over a stretching curved surface with heat and mass transfer

Analysis of efficiency and performance evaluation criterion of nanofluid flow within a tube enhanced with perforated triple twisted tape: A two-phase analysis

Thermo-hydraulic performance evaluation and comparison of SiC-MWCNT and Al2O3-MWCNT Non-Newtonian hybrid nanofluids using a heat exchanger equipped with helically corrugated tubes: an experimental study

Evaluation of thermal performance factor by hybrid nanofluid and twisted tape inserts in heat exchanger

Turbulent heat transfer and flow analysis of hybrid Al2O3-CuO/water nanofluid: An experiment and CFD simulation study

An Experimental Study to Determine the Maximum Efficiency Index in Turbulent Flow of SiO2/water Nanofluids

Thermal analysis of nanofluids flow in a double pipe heat exchanger with twisted tapes insert in both sides

A Computational Fluid Dynamics Study of Laminar Forced Convection Improvement of a Non-Newtonian Hybrid Nanofluid within an Annular Pipe in Porous Media

Experimental Investigation of nanofluid heat transfer in a square cross-sectional duct

Rotating Flow and Heat Transfer of Single-Wall Carbon Nanotube and Multi-Wall Carbon Nanotube Hybrid Nanofluid with Base Fluid Water over a Stretching Sheet

Enhancing Heat Transfer Performance: Nanofluids Application in Helical Microfin Tube Concentric Heat Exchangers

Numerical investigation of thermal performance augmentation of nanofluid flow in microchannel heat sinks by using of novel nozzle structure: sinusoidal cavities and rectangular ribs

Laminar Mixed Convection Heat Transfer Analysis in Horizontal Annuli using Hybrid Nanofluid

Effect of twist ratio on the thermal-hydraulic behavior of an aluminum oxide/cupric oxide nanofluid heat exchanger