Abstract:Microwave-induced in situ amorphization of a drug into a polymeric amorphous solid dispersion (ASD) has been suggested to follow a dissolution process of the drug into the polymeric network, at temperatures above the glass transition temperature (Tg) of the polymer. Thus, increasing the compact temperature, above the Tg of the polymer, is expected to increase the rate of drug dissolution in the mobile polymer, i.e., the rate of amorphization, in a direct proportional fashion. To test this hypothesis, the present study aimed at establishing a linear correlation between the compact temperature and the rate of drug amorphization using celecoxib (CCX) and the polymers polyvinylpyrrolidone (PVP) 12 and PVP17 as the model systems. Water sorbed into the drug-polymer compacts during 2 weeks of storage at 75% relative humidity was used as the dielectric heating source for the present drug amorphization process, and therefore directly affected the compact temperature during exposure to microwave radiation; the loss of water during heating was also studied. For this, compacts prepared with 30 wt% CCX, 69.5 wt% PVP12 or PVP17 and 0.5 wt% magnesium stearate (lubricant) were conditioned to have a final water content of approx. 20 wt%. The conditioned compacts were exposed to microwave radiation for 10 min at variable power outputs to achieve different compact temperatures. For compacts containing CCX in both PVP12 and PVP17, a linear correlation was established between the measured compact end temperature and the rate of drug amorphization during 10 min of exposure to microwave radiation. For compacts containing CCX in PVP12, a fully amorphous ASD was obtained after 10 min of exposure to microwave radiation with a measured compact end temperature of 71 °C. For compacts containing CCX in PVP17, it was not possible to obtain a fully amorphous ASD. The reason for this is most likely that a fast evaporation of the sorbed water increased the Tg of the conditioned drug-polymer compacts to temperatures above the highest reachable compact temperature during exposure to microwave radiation in the utilized experimental setup. Supporting this conclusion, evaporation of the sorbed water was observed to be faster for compacts containing PVP17 compared to compacts containing PVP12.

Characteristics and Mechanism of Microwave-assisted Drying of Amorphous Paclitaxel for Removal of Residual Solvent

Phase Transition and Micellization of Temperature Responsive Dextran-graft-poly （N-Isopropylacrylamide） Polymers

Microwave Heating and Devolatilization Characteristics of Polyethylene Particles in a Fixed‐bed Devolatilizer

Microwave Vacuum Drying Properties and Kinetics Model of Radix Paeoniae Rubra Extract

Adsorption Kinetics, Mechanism, Isotherm, and Thermodynamic Analysis of Paclitaxel from Extracts of Taxus chinensis Cell Cultures onto Sylopute

Ultrasonic Cavitation Bubble-assisted Adsorption of Paclitaxel from Cell-free Culture Supernatants of Taxus chinensis onto Diaion HP-20

Study of the Extraction Kinetics and Calculation of Effective Diffusivity and Mass Transfer Coefficient in Negative Pressure Cavitation Extraction of Paclitaxel from Taxus chinensis

Modeling Simultaneous Heat and Mass Transfer for Microwave Drying on Apple

Investigation of molecular interactions between paclitaxel and DPPC by Langmuir film balance and differential scanning calorimetry.

Elucidation of the Mechanism and Kinetics of Ultrasonic Extraction of Paclitaxel from Plant Cell Cultures of Taxus chinensis

Computational studies on self-assembled paclitaxel structures: Templates for hierarchical block copolymer assemblies and sustained drug release

Determination of Paclitaxel Solubility in Carbon Dioxide Using Quartz Crystal Microbalance

Preparation and Targeted Release Evaluation Studies on Micro-Encapsulation of Paclitaxel

Release of paclitaxel from polylactide-co-glycolide (PLGA) microparticles and discs under irradiation

Molecular dynamics of paclitaxel interaction with cyclodextrin-modified core-shell micelles

Ultrasound-negative pressure cavitation extraction of paclitaxel from Taxus chinensis

Effect of microwave-assisted vacuum and hot air oven drying methods on quality characteristics of apple pomace powder

Negative pressure cavitation fractional precipitation for the purification of paclitaxel from Taxus chinensis

Studying the Impact of the Temperature and Sorbed Water during Microwave-Induced In Situ Amorphization: A Case Study of Celecoxib and Polyvinylpyrrolidone

Drying Kinetics of Microwave-Assisted Drying of Leaching Residues from Hydrometallurgy of Zinc

Ultrasonic cavitation bubble- and gas bubble-assisted adsorption of paclitaxel from Taxus chinensis onto Sylopute