Abstract:Abstract The development in Iraq, in addition to the increase in the population and the increase in the standard of living, has led to a marked increase in the demand for water, as the shortage of fresh water resources has become a problem that concerns specialists and decision-makers as it affects the water deficit, especially in the provision of drinking water (the basis of life) in addition to other requirements such as agriculture. Which led to the search for other possible solutions available. One of these solutions is the reuse of treated wastewater in agriculture or any other uses to save fresh water and expand agricultural areas after removing high concentrations of nutrients such as nitrogen and phosphorous. The aim of the study is to improve the performance of the treatment method used by the sewage treatment plant to achieve the removal of nutrients from the treated water. The dual use of a biological treatment and chemical precipitation process to remove phosphorous compounds from wastewater was studied. To avoid instability in the biological treatment method due to temperature changes during the year, especially in the summer. The obtained wastewater treatment plant validation was verified by applying the existing plant planning in GPS-X 8.0 modeling and simulation software, by combining biological and chemical removal methods to improve the performance of a wastewater treatment plant in Khairy in Al Diwaniyah, Iraq (KWWTP). The results showed that a series of conditions for anaerobic, oxygen and aerobic reactors help to remove biological nutrients efficiently. The concentration of COD, BOD and TSS were below the permissible environmental parameters. The removal rate of nitrogen as N-NH3 is 92.96; 94.93; 97.60% respectively. The phosphorous removal rate is 80.22, 86.55, 92.30 respectively Except for the release of nitrogen and phosphorous compounds during the summer (July and August) due to the sensitivity of phosphorous-containing organisms to the influence of temperature. The increasing concentrations of phosphorous produced in the summer were treated by adding doses of chemicals (alum) at different stages of the wastewater treatment plant, and the required dose of Alum ranges in the range of 0.5-0.9 kgAl / kg P, according to the dose strategy that achieves the highest efficiency of the KWWTP.

The Bacteria Addition Study to Batik Wastewater Industries In pH Performance, and Removal of Ammonia and COD

Studies of Bacillus subtilis NAP1 to degrade BOD, COD, TSS, and pH: The indigenous bacteria in Indonesia batik wastewater

Removal of Color, Phenol and Sulfide from Batik Wastewater using Immobilized Bacillus licheniformis in Bentonite Mineral

Microbial degradation of batik waste water treatment in Indonesia

Coagulation-flocculation treatment for batik effluent as a baseline study for the upcoming application of green coagulants/flocculants towards sustainable batik industry

Integrated physical-biological treatment system for batik industry wastewater: A review on process selection

Behaviors and Mechanism of Color, COD, and Silica Removals in the Electrocoagulation of Batik Wastewater Using Waste Aluminum Electrodes

Advanced Bamboo Industry Wastewater Treatment Through Nanofiltration Membrane Technology

Characterisation of Laboratory Wastewater for Planning Wastewater Treatment Plants in a University Campus in Indonesia

PROJECT DESIGN AND RUN OF BATIK PRINTING WASTEWATER TREATMENT

Sustainability of Batik wastewater quality management strategies: analytical hierarchy process

Automation System Architecture of pH Neutralization Process in Batik Wastewater Treatment Plant

Application of anaerobic and aerobic bioreactors in detergent wastewater treatment: A review

Efficient Nitrification Treatment of Comprehensive Industrial Wastewater by Using Novel Mass Bio System

Analysis of Algae and Bacteria Mixture in Removing Pollutants from Laundry Wastewater

An efficient and economical treatment for batik textile wastewater containing high levels of silicate and organic pollutants using a sequential process of acidification, magnesium oxide, and palm shell-based activated carbon application

TREATMENT OF AN ALKALINE BUTYL RUBBER WASTEWATER BY THE PROCESS OF COAGULATION AND FLOCCULATION HYDROLYSIS ACIDIFICATION - BIOLOGICAL CONTACT OXIDATION - MBR

Development of anaerobic ammonium oxidation (anammox) for biological nitrogen removal in domestic wastewater treatment (Case study: Surabaya City, Indonesia)

Removal of nitrogen-phosphorus in food wastewater treatment by the Anaerobic Baffled Reactor (ABR) and Rotating Biological Contactor (RBC)

Performance of temperature changes and dosage for enhancement of nitrogen and phosphorus removal from wastewater: A comparative study

Experimental Approach for Chemical Oxygen Demand and Ammonia Nitrogen Removal from Natural Rubber Wastewater via Adsorption by Kaolin