Abstract:In operation, residual stresses will superimpose with load stresses affecting service life of welded constructions. Therefore, knowledge of the exact residual stress state is of great interest already in the design state. Experimental determination of residual stresses is possible using destructive and non-destructive methods. Especially for larger structures and small batch sizes destructive measuring techniques can be neglected. Non-destructive methods, however, do have process-specific disadvantages such as the limited resolution. Furthermore, residual stress gradients in the direction of sheet thickness cannot be determined. An alternative approach would be the virtualization of the design using the finite element method (FEM). The application of FEM gives an insight into residual stresses at each point of the computed model, in particular at areas which are not accessible to measurement. However, the use of the FEM for residual stress calculation is subject to certain limits and error sources due to the fine discretization and the high degree of non-linearity. In particular, the calculation of multi-layer welds will reach high computation times, even with high available computing capacities. Therefore, the calculation's practical benefit is hardly recognizable. This known issue is often counteracted with radical simplification of the welding task to be calculated. Simplification approaches such as reduction of layer numbers or semi-transient calculations result in manageable computing times, but can also lead to result accuracies, the quality of which must be questioned. This led to the following questioning. Which simplification strategies are applicable in numerical welding simulation in order to achieve acceptable accuracy by means of an application-oriented manner? For this purpose, reference models were produced that were experimentally verified. On this basis, simplification approaches were investigated numerically and their effects on result quality were quantified. It could be shown that most of the commonly used simplification approaches for the calculation of residual stresses and distortions are only partially permissible, if any.

Modeling of the thermally induced residual stresses during laser transmission welding of thermoplastics

ICONE19-43939 Phenomenological Evaluation of Laser-Irradiated Welding Processes with a Combined Use of Higher-Accuracy Experiments and Computational Science Methodologies : (5) Numerical Simulation of the Welding Processes with a Multi-Dimensional Multi-Physics Analysis Code SPLICE

The Numerical Simulation of Welding Residual Stress of Dissimilar Transparent Thermoplastics with MZA Powder Absorbent

Development of Laser Welding Simulation Code with Advanced Numerical Models

A numerical model for the thermoplastic welding process

An Eulerian thermomechanical elastic–viscoplastic model with isotropic and directional hardening applied to computational welding mechanics

The Effect of Thermal Residual Stress on the Stress State in a Short-Fiber Reinforced Thermoplastic

Residual stresses with time-independent cyclic plasticity in finite element analysis of welded joints

Finite element simulation of laser transmission thermoplastic welding of circular contour using a moving heat source

A Three-Dimensional Thermal Finite Element Model of Laser Transmission Welding for Lap-Joint

Infrared observations and finite element modeling of a laser transmission welding process

Numerical Simulation of Laser Transmission Welding—A Review on Temperature Field, Stress Field, Melt Flow Field, and Thermal Degradation

Evaluation of material based influences at laser based heat conduction welding of carbon fiber reinforced plastics

Simplified residual stress and distortion calculations of multi-pass welds and their possible influence on result quality

Numerical and experimental investigation into the evolution and distribution of residual stress in laser transmission welding of PC/Cu/PC

Validation of a Theoretical Model for Laser Welding Thermal Field by Multi-Physics Numerical Simulation

POTENTIALS OF THE ALE-METHOD FOR MODELING PLASTICS WELDING PROCESSES, IN PARTICULAR FOR THE QUASI-SIMULTANEOUS LASER TRANSMISSION WELDING

Numerical modeling and simulation for laser beam welding of ultrafine-grained aluminium

Multiphysics Study of Thermal Profiles and Residual Stress in Welding

Measurement and Simulation of Residual Stresses in Laser Welded CFRP/steel Lap Joints

Stress evolution mechanisms under different SSPT-related effects during laser welding