Abstract:Aluminum particle ignition behavior in open atmosphere rocket propellants fires is of particular interest for preventing accidents for rockets carrying high-value payloads. For nominal motor pressures, aluminum particles oxidize to aluminum oxide in the gas phase and release significant combustion energy while minimizing motor instability. During rocket abort or launch pad malfunction which occur under atmospheric or low pressure, behavior of aluminum particle combustion becomes complex and aluminum appears to melt, agglomerate or form a skeletal structure. Furthermore, an oxide shell of alumina instantly forms on any fresh aluminum surface which is exposed to an oxidizing environment. Aluminum combustion then strongly depends on the oxide layer growth, which is influenced by causative factors, including particle size, environmental gas composition, and heating rate. This work focuses on the effect of the oxide barrier which forms on the surface of aluminum that is recognized to impede combustion of aluminum in solid rocket propellants. Understanding the mechanism for breach of this barrier is deemed to be an important consideration in the overall process. In this discussion, results of various experiments will be discussed which have a bearing on this process. Basically, a recognized criterion is the melting of the oxide layer at 2350 K is sufficient. However, in other situations, depending on the mechanism of oxide formation, there will occur defects in the oxide shell which provide for aluminum ignition at lower temperatures. For slow heating in an oxidizing environment, where the oxide layer can grow thick, then ignition is more difficult. Because there is no uniform model to establish an ignition criterion due to the unknown history of an aluminum particle, this paper reports experimental findings involving oxyacetylene torch, thermogravimetric analysis with differential scanning calorimeter, aluminum particle heating, electric ignition and aluminum powder heating, to address the influence of the oxide layer on the aluminum particle ignition.

Problems of Assessing Ignition Capability of Aluminum Particles in Electrical Wiring When a Short Circuit Occurs

Exploring the Combustion Mechanism of Single Micron-Sized Aluminum Particles with a Numerical Model

Aluminum Particle Ignition Studies with Focus on Effect of Oxide Barrier

Investigation into the overcurrent failure and combustion characteristics of copper‐clad aluminum conductors

Thermal theory of aluminum particle ignition in continuum, free-molecular, and transition heat transfer regimes

Predictive Model for the Ignition and Combustion Behaviors of Micron-Sized Aluminum Particles in a Water Vapor Environment

Experimental Research on Heat Transfer and Ignition Characteristics of Series Fault Arc Combustion in 220VAC Power System

Theoretical analysis on the ignition of a combustible mixture by a hot particle

Ignition and Combustion of Aluminum Hydride Dust Aerosols

Simulation of Ignition of Composites by Particles Heated to a High Temperature

Experimental and theoretical research on the temperature evolution law of overcurrent fault wires

Influence of the Hierarchy Structure of Aluminum Particles on Density, Combustion Efficiency, and Ignition Delay

Analysis and Modeling of Ignitability of Polymers in the UL-94 Vertical Burning Test Condition

Experimental Study on Dynamic Combustion Characteristics of Aluminum Particles

Investigation into the Mechanism of Ignition of Magnesium Alloy Plates by High-Temperature Molten Droplet

Glowing Contact in Electrical Fires: Experimental Investigation and Modeling on Its Heat Intensity and Thermal Hazards

Measurement of the temperature of burning aluminum particles using multi-spectral pyrometry

Ignition sensitivity and explosion behaviors of micron-sized aluminum powder: Comparison between flake aluminum powder and spherical aluminum powder

An experimental study on the combustion process and thermodynamic characteristic parameters of copper wire overcurrent fault

Experimental Study of Spontaneous Ignition of Overloaded Electrical Wires under Transverse Wind

The Effect of Aluminum in Its Mixtures With Ammonium Nitrate on the Ignition of Burning and Its Transition to the Convective Burning Regime