Neutronic Analysis of Accident‐Tolerant Cladding Materials in 3D Full Core BEAVRS PWR Benchmark Using OpenMC Code
Khalid A. Alamri,Meshari M. Alqahtani,Abdullah S. Alomari,Abdullah I. Almarshad
DOI: https://doi.org/10.1155/2024/8811265
IF: 4.6
2024-06-04
International Journal of Energy Research
Abstract:After the Fukushima Daiichi nuclear accident in 2011, the performance of nuclear fuel during accidents became a matter of great concern. To address this, a new type of fuel technology called accident‐tolerant fuel (ATF) has been developed with the goal of enhancing the ability of light water reactors (LWRs) to withstand severe accident conditions. Iron‐based alloys have been suggested as potential candidates for fuel cladding due to their favourable thermomechanical properties, lower reactivity with steam, and lower hydrogen generation. This study evaluates the neutronic performance of C26M (a 2nd generation nuclear grade FeCrAl alloy), APMTTM, 310SS, and 304SS cladding materials by comparing them with Zircaloy‐4 cladding in a 3D PWR core at the beginning of the cycle (BOC) using OpenMC code. The results revealed that the neutronic penalty varied for different alternative cladding materials where C26M exhibited the lowest neutronic penalty value of ‐12551 pcm, while 310SS demonstrated the highest with a value of ‐17855 pcm. Additionally, important parameters in the reactor core such as neutron spectrum, reactivity coefficients, boron worth, control rod bank worth, power distribution, and radial thermal neutron flux distribution are evaluated and discussed. The analysis results showed that C26M provided a significantly higher level of neutronic performance compared to APMTTM, 304SS, and 310SS. Although this study primarily focused on the neutronic performance of PWRs at BOC, future research should encompass fuel depletion analysis to delve deeper into the potential of alternative cladding materials.
energy & fuels,nuclear science & technology