Abstract:Oil sludge is one of the main pollutants generated by the oil industry. Due to serious pollution and increasing oil production, problems arise every year in the effective treatment of oil sludge. The current study examines the composition and physicochemical characteristics of oil sludge, as well as traditional and new methods for processing oil sludge. With the tightening of environmental protection requirements, oil sludge quality reduction, recycling, and harmless treatment technologies will become necessary in the future. The primary task was to determine the composition of tank oil sludge, separate it from mechanical impurities, and study the influence of ultrasonic treatment and subsequent atmospheric distillation on the extract. The separation of the concentrate and the composition of the tank oil sludge, using an extracted mixture of hexane and benzene, are considered. The use of modern SEM methods, elemental analysis, NMR analysis, IR, ultrasound, and GC–mass spectrometry made it possible to characterize the organic part of reservoir oil sludge and its distillation products. First, 300 g of tank oil sludge was preheated and mixed with 300 mL of solvent (hexane:benzene = 1:1). After mixing with the solvent, the result mixture was filtered. Then, it was placed in an ultrasonic bath and exposed to ultrasound at a frequency of 100 kHz for 30 min. After processing, it was extracted in a Soxhlet apparatus at a temperature of 65 °C to isolate the extract. The resulting extract was analyzed on a gas chromatograph with mass detection. The composition of the extract was as follows (in %): hexane—83.99; total hydrocarbon isomers—7.12; n-hydrocarbons—2.52; benzene—6.37%. At a temperature of 85 °C, the benzene yield was 65.85%. It has been established that the fractions obtained through the distillation of oil sludge at temperatures of 65–85 °C have improved dissolving capacity. It has also been shown that the use of these fractions promotes an increase in the content of hydrocarbon isomers by 12–13% in the extract composition.

Methods of separation of stable oil-water emulsions into phases and their application at production sites

Superhydrophilic/underwater Superoleophobic Oil-in-water Emulsion Separation Membrane Modified by the Co-Deposition of Polydopamine and Chitosan-Tripolyphosphate Nanoparticles

SEPARATION OF OIL-WATER EMULSIONS FROM THE OILS OF THE EAST SIBERIAN FIELDS

Studying the Characteristics of Tank Oil Sludge

Study on Oil Separation from Oil/Water Emulsion via Coagulation and Ultrafiltration

Separation of silicone oil droplets dispersed in activated sludge

The Formation, Stabilization and Separation of Oil–Water Emulsions: A Review

Removal of emulsified water in petroleum sludge using micro-emulsion method

Application of surfactants for the resolution of emulsions and suspensions in slop oil storage tanks, cleaning, and final disposal

Problems of previous local treatment wastewater of oil production and their effective solution

Processing of Oil-Tank Sludge by Hydrothermal Dispersion using polycomplexants and Amino-Acid-Salts

Probe into a novel surfactant-free microemulsion system of ethylene glycol monobutyl ether + water + diesel for crude oil removal and recovery from oily sludge

Emulsion system, demulsification and membrane technology in oil–water emulsion separation: A comprehensive review

Research of emulsion properties of oil with selection of effective chemical reagents for destruction of arising emulsions

Stability Analysis of Pure Oil-Water Emulsion in Gravity-Based Separators

Research status and analysis of stabilization mechanisms and demulsification methods of heavy oil emulsions

Complex selection of a demulsifier: laboratory studies, numerical simulation and field tests

Separation of Oil Phase from Dilute Oil/Water Emulsion in Confined Space Apparatus

Separate Reclamation of Oil and Surfactant from Oil-in-Water Emulsion with a CO 2 -Responsive Material

Continuous Separation Process of Water-in-Crude Oil Emulsion by Simultaneous Application of an Electrical Field Combined with a Novel Absorbent Based on Functionalised PolyHIPE Polymer

Coalescence and separation of surfactant-stabilized water-in-oil emulsion via membrane coalescer functionalized by demulsifier