Abstract:Dynamic stall on the blades of low-solidity vertical axis wind turbines (VAWTs) is a major problem due to its adverse effects on performance, drive-train components, and generator sizing. However, when the turbine chord-to-radius ratios are relatively large, greater than approximately 0.5, counterintuitively, dynamic stall can be harnessed to produce useful torque. To examine this seeming contradiction, a wind tunnel study was conducted on a two-bladed, H-rotor test-turbine where the blade chord-to-radius ratio, blade profile (NACA 0012 and NACA 0021), preset angle, strut-blade offset (connection point), and Reynolds number were varied systematically. Large chord-to-radius ratios, between 0.6 and 1.2, and hence high solidities, were selected to ensure that the maximum driving torque was produced by dynamic stall. At low Reynolds numbers (<10 5 ), turbine performance with NACA 0021 blades was vastly superior to that with the thinner NACA 0012 blades, producing approximately 90% greater power and torque coefficients at blade tip-speed ratios between 0.8 and 1.6. This difference was due mainly to the vastly different dynamic stall behavior of the two profiles. The high turbine power coefficients, C P, max >0.3, were obtained with the NACA 0021 blades when the preset angles were close to zero and the strut-blade offset was at the mid-chord location. Tuft-based flow visualization showed that an aft dynamic stall vortex on the NACA 0021 blades precedes the conventional leading-edge vortex, also present on the NACA 0012 blades, resulting in substantially greater post-stall dynamic lift. Nevertheless, NACA 0012 showed a far stronger Reynolds number dependence. In addition, the similarity between preset and offset effects was explained by a new approach to describing the virtual preset angle dependence on the offset point.

Dynamic Stall of a Vertical-Axis Wind Turbine and Its Control Using Plasma Actuation

Dynamic Stall Control for a Vertical-Axis Wind Turbine Using Plasma Actuators

Numerical simulation of dynamic stall flow control using a multi-dielectric barrier discharge plasma actuation strategy

Dynamic-stall-driven vertical axis wind turbine: An experimental parametric study

Study on the Active Control of the Dynamic Stall of Rotor Airfoils Based on Plasma Excitation

The dynamic stall dilemma for vertical-axis wind turbines

Validation of an Actuator Line Model Coupled to a Dynamic Stall Model for Pitching Motions Characteristic to Vertical Axis Turbines

Wind Tunnel Experiments and Numerical Study on Performance Characteristics of an H-type Vertical Axis Wind Turbine in the Spanwise Direction

Improving vertical-axis wind turbine performance through innovative combination of deflector and plasma actuator

Vorticity and Its Relationship to Vortex Separation, Dynamic Stall, and Performance, in an H-Darrieus Vertical-Axis Wind Turbine Using CFD Simulations

Unsteady Navier-Stokes studies on loads, wake and dynamic stall characteristics of a two-bladed vertical axis wind turbine

Aerodynamic analysis of a novel pitch control strategy and parameter combination for vertical axis wind turbines

Dynamic stall in vertical axis wind turbines: scaling and topological considerations

Research on Dynamic Stall of 3D Wind Turbine under Wind Speed Fluctuation

Swept Blade for Performance Improvement on a Vertical Axis Wind Turbine

Dynamic stall of vertical-axis-wind-turbine rotor blades equipped with Gurney flaps and vortex generators

Dynamic stall of an experimental wind turbine blade

Ameliorating a vertical axis wind turbine performance utilizing a time-varying force plasma actuator

Aerodynamic performance improvement analysis of Savonius Vertical Axis Wind Turbine utilizing plasma excitation flow control

Aerodynamic load control on a dynamically pitching wind turbine airfoil using leading-edge protuberance method

Timescales of dynamic stall development on a vertical-axis wind turbine blade