Abstract:Taking the loess high-fill project of Lv Liang airport in China as the research object, large-scale centrifugal tests were carried out to investigate the deformation characteristics of the collapsible loess ultrahigh-fill slope under natural moisture content and saturated state by using a joint model of undisturbed loess and remolded loess. The results show that the consolidation deformation of the collapsible loess ultrahigh-fill slope is the main factor causing its deformation. The post-construction deformation amount and deformation rate are large in the early stage, and the relationship between the post-construction deformation and thickness of filling body is linear. When the water content of soil increases due to infiltration, the consolidation of the filling body and the collapse of the undisturbed foundation loess will cause settlement and deformation of the slope. The slope may crack along the soft zone formed when the water infiltrates. When failure occurs, the sliding surface will pass through the collapsible soil layer. The contact surface between the collapsible loess layer and the adjacent soil layer is part of the sliding surface, and the contact surface with a relatively low strength will be damaged first. When the strength difference between adjacent soil layers is large, the upper soil layer on the slip surface shows a typical translational sliding mode. The slip surface is approximately arc-shaped, and there is a transition layer with a specific thickness between the slip surface and contact surface. The water content of the high-fill slope has a great influence on the post-construction settlement of the slope crest and slope stability. The post-construction settlement of the slope crest increases with the increase in the water content of the filling body, and the stability coefficient of the slope decreases with the increase in the water content of the filling body. In the saturated state, the sliding force of soil increases, the shear strength decreases, and the stability of high fill slope decreases. Therefore, it is necessary to strengthen the inspection of the rationality of drainage system design in slope construction to ensure slope safety.

Elastoplastic damage seepage–consolidation coupled model of unsaturated undisturbed loess and its application

An Elastic-Plastic Constitutive Model for Unsaturated Structural Loess

Stability Analysis of Overconsolidated Unsaturated Red Clay Slope Based on Modified UH Model

A New and Simple Method for Predicting the Collapse Susceptibility of Intact Loess

Collapsibility Mechanisms and Water Diffusion Morphologies of Loess in Weibei Area

Evaluation of Structural Strength and Parameters of Collapsible Loess

Wetting-Induced Collapse Behavior of Unsaturated and Structural Loess under Biaxial Tests Using Distinct Element Method

The Structure Degradation of a Silty Loess Induced by Long-Term Water Seepage

Field model experiments and numerical analysis of rainfall-induced shallow loess landslides

New method for the mechanical characteristics of self-weight collapsibility testing of loess foundation based on centrifugal model test

Application of binary medium model in deformation analysis of loess during wetting

Experimental Study on the Penetration of Natural Unsaturated and Collapsible Loess Based on the Permeability Velocity

An experimental investigation on undrained cyclic behaviour of a saturated intact loess

Experimental investigation of the collapsibility of loess subjected to water invasion

Research on the collapsibility of loess after water immersion

A simple method for predicting wetting-induced collapse behavior of compacted loess with various initial void ratios and moisture contents

Study on Deformation Characteristics of Loess Ultrahigh-Fill Slope Based on Large-Scale Undisturbed Soil Centrifugal Model Tests

Study on the strength and deformation characteristics of loess under multi-staged unloading

The structural evolution of undisturbed loess due to water infiltration

Mechanism of loess planar erosion and numerical simulation based on CFD–DEM coupling model