System of Automatic Control for Solid/liquid Ratio in Mills with Circulating Load

Vasily Kondratets,Oleksandr Serbul,Oleksandr Didyk,,,

DOI: https://doi.org/10.32515/2414-3820.2021.51.203-210

2021-01-01

Abstract:The operation of a ball mill operating in a closed loop with a spiral classifier depends on the vacuum of the pulp in it, which is characterized by a solid / liquid ratio. Supply to the entrance of the ball mill at the same time ore and sand classifier, as well as changes in the circulating load in a wide range greatly complicate the definition of this technological parameter. This situation has led to the fact that the solid / liquid ratio in mills operating in such conditions can not be automatically adjusted, in turn, the deviation of the pulp vacuum from the required value leads to significant losses. The study of the ball mill as a controlled object on the pulp vacuum channel made it possible to describe it using the mathematical expression given in the article. The solution of this expression makes it possible to characterize the change in the mass of the material in the mill over time, provided that a stepwise action is introduced at the entrance - the volume flow of water or ore. A constant value of the mass of material in the mill will clearly characterize the corresponding solid/liquid ratio. It has been found that it is important to study the filtering capabilities of the control object, as control actions on water and disturbing actions on ore can significantly change the vacuum of the pulp in some areas of the mill. The filtering capabilities of the mill can be investigated by its amplitude frequency characteristics, which showed that at low circular frequencies the amplitude frequency characteristics depend on the mode of operation of the mill - the magnitude of the circulating load and the cost of the source ore. Using computer technology, spatial diagrams of the relative oscillations of the mass of material in the mill from the amplitude and frequency of influences at its entrance through the ore and water. In the course of theoretical research it was determined that the only approach to ensure the required accuracy of determining the solid / liquid ratio in these conditions is to filter the signals before applying to the input of the identification unit of the ratio. Thus, the system of automatic control of the solid/liquid ratio at the entrance to the mill is implemented on microprocessor means. Its operation on the laboratory test bench made on the microcontroller showed high accuracy of stabilization of technological parameter, reliability in various conditions of change of characteristics of input signals.