Abstract:A series of characterizations (including in situ X‐ray diffraction, in situ Raman, X‐ray photoelectron spectroscopy, scanning electron microscope) and electrochemical tests (in situ electrochemical impedance spectroscopy, open‐circuit potential) together with density‐functional theory calculation consistently demonstrate that the in situ photoelectrochemical (PEC) activation promotes the surface reconstruction of BiVO4 photoanodes with greatly increased {040} crystal face and vanadium/oxygen vacancies and finally boosts PEC performance. BiVO4 has been widely concerned due to its great potential in photoelectrochemical (PEC) water splitting. However, low carrier mobilities and high recombination efficiency of photogenerated carriers impede its photocatalytic performance. Herein, an in situ PEC cyclic‐voltammetry‐induced surface reconstruction of BiVO4 photoanodes (BVO pristine) is developed with significantly enhanced efficiency for solar water splitting. A series of in situ characterizations (including in situ X‐ray diffraction, in situ Raman), together with electrochemical tests and density‐functional theory calculations, reveal that during the photoelectrical activation process, the BVO pristine surfaces undergo a crystal plane reconstruction with greatly increased {040} crystal face to promote the separation of photogenerated carriers. In addition, abundant vanadium vacancies and oxygen vacancies are also introduced into the BiVO4 surface during the crystal face reconstruction process with more favorable surface water adsorption and increased injection efficiency of photogenerated carriers. Therefore, the charge‐transfer resistance (Rct) between BVO pristine and electrolyte under AM 1.5G illumination substantially reduced from the original 15 200 to 2820 Ω after the activation. Moreover, the photocurrent density of activated BVO pristines increases more than 12 times, relative to the original BiVO4. In this work, a new horizon for in situ photoelectric activation of semiconductor photoelectrodes with significantly enhanced PEC water splitting is provided.

Tuning surface electronegativity of BiVO4 photoanodes toward high-performance water splitting

Dual Modification of BiVO4 Photoanode by Enriching Bulk and Surface Oxygen Vacancies for Enhanced Photoelectrochemical Performance.

BiVO4 photoelectrodes for unbiased solar water splitting devices enabled by electrodepositing of Cu2O simultaneously as photoanode and photocathode

High-Performance Ultrathin BiVO4 Photoanode on Textured Polydimethylsiloxane Substrates for Solar Water Splitting

Modulating built-in electric field via Bi-VO4-Fe interfacial bridges to enhance charge separation for efficient photoelectrochemical water splitting

Boosting charge separation and transfer at the boron-triggered BiVO 4 interface for efficient and stable solar water splitting

Surface Modulation Inducing Bismuth-Rich Surface Composition in BiVO 4 for Efficient Photoelectrochemical Water Splitting

Synergistic Surface Engineering of BiVO4 Photoanodes for Improved Photoelectrochemical Water Oxidation

High-performance and stable BiVO4 photoanodes for solar water splitting via phosphorus-oxygen bonded FeNi catalysts

In Situ Photoelectrochemical‐Induced Surface Reconstruction of BiVO4 Photoanodes for Solar Fuel Production

New BiVO4 Dual Photoanodes with Enriched Oxygen Vacancies for Efficient Solar-Driven Water Splitting

Coupling surface modification with cocatalyst deposition on BiVO4 photoanode to enhance charge transfer for efficient solar-driven water splitting

Boosting the Performance of BiVO4 Photoanodes by the Simultaneous Introduction of Oxygen Vacancies and Cocatalyst Via Photoelectrodeposition.

Charge Transport Enhancement in BiVO4 Photoanode for Efficient Solar Water Oxidation

Enhanced photoelectrochemical water oxidation over a surface hydroxylated BiVO4 photoanode: advantageous charge separation and water dissociation

High transmittance BiVO 4 thin-film photoanodes by reactive magnetron sputtering for a photovoltaic-photoelectrocatalysis water splitting system

General and Robust Photothermal‐Heating‐Enabled High‐Efficiency Photoelectrochemical Water Splitting

BiVO4 Photoanodes Modified with Synergetic Effects between Heterojunction Functionalized FeCoOx and Plasma Au Nanoparticles

Ni-Doped BiVO4 photoanode for efficient photoelectrochemical water splitting

Enhancing photoelectrochemical water splitting by combining work function tuning and heterojunction engineering

Facile Synthesis of a Micro–Nano-Structured FeOOH/BiVO4/WO3 Photoanode with Enhanced Photoelectrochemical Performance