Abstract:Effects of heat treatment on the microstructure and performance of laser-welded joint for the novel heat-resistant aluminum alloy Al–12Ce–0.4Sc were studied. The results show that heat treatment has little effect on the tensile properties of welded joints at room temperature but exhibits a significant effect on the creep properties at high temperature of 300 °C. The microhardness distribution in the fusion zone is uniform, with a value significantly higher than that of the aluminum base in the base material, but lower than that of the large blocky Al 11 Ce 3 phase. Fractures occurred in the base material during the tensile tests at both room temperature and 300 °C high temperature for all joints. The elongation during the tensile test at 300 °C high temperature of the joint welded by cast base material (CA-LW) was approximately twice as high as that of the joint with post-heat treatment welded by cast base material (CA–LW–HT). The CA–LW–HT joint exhibited the best creep resistance with a steady-state creep rate of 3.2 × 10–8 s −1 at 300 °C and 55 MPa, which was two orders of magnitude lower than that of the CA–LW joint. A significant reduction in grain size and change in the form of the precipitated phases in the fusion zone were identified as the primary reasons for higher microhardness and strength in the fusion zone than in the base material. The grain size in the fusion zone was less than 1/10 of that in the base material, and large blocky primary Al 11 Ce 3 in the base material almost completely disappeared after the welding process, as the microstructure transformed into eutectics of primary α -Al and nanoscale Al 11 Ce 3 /Al. Mild Sc enrichment observed at the Al 11 Ce 3 /Al matrix interface in the fusion zone significantly contributed to the maintenance of outstanding high-temperature performance in the fusion zone.

Influence of thermal treatment on the phase transitions of high-strength laser welding joints of aluminium-lithium alloys

Effect of post-weld heat treatment on the microstructure, phase composition and mechanical properties of dissimilar Al-Mg-Li/Al-Cu-Li laser welded joints

The Influence of Heat and Cryogenic Treatment on Microstructure Evolution and Mechanical Properties of Laser-Welded AZ31B

Effect of thermal treatments on the microstructure and local mechanical behaviour of a laser beam welded CoCuFeMnNi high-entropy alloy

Structure and mechanical properties of aluminum-lithium alloy 1420 with a weld

Effect of Heat Treatment on the Structure and Properties of Laser Welded Joints of Aluminum Alloy AA2024

Mechanical behavior and microstructure evolution of Al-Cu-Mg alloy produced by laser powder bed fusion: Effect of heat treatment

Microstructure and performance of high-speed laser-welded joints in novel heat-resistant Al–12Ce–0.4Sc alloy

Effect of heat treatments on microstructure and mechanical behavior of laser welded LPBF AlSi10Mg alloys

Influence of aging heat treatment on microstructure and tensile properties of laser oscillating welded TB8 titanium alloy joints

Effects of heat treatment on microstructure and mechanical properties of double-sided laser-welded AA2060/AA2099 T-Joint

Effect of Post-Weld Heat Treatment on Microstructure and Properties of Ti-23al-17nb Alloy Laser Beam Welding Joints

Influence on the strength and aging resistance of aluminium joints by laser pre-treatment and surface modification

Evolution mechanism of interfacial microstructure and regulation of mechanical properties of laser-arc hybrid weld-brazing aluminum/steel joints under different post-welding heat-treatment temperatures

Investigation of the microstructure and mechanical properties of Mg–Al–Zn alloy joints formed by different laser welding processes

Microstructural, Porosity and Mechanical Properties of Lap Joint Laser Welding for 5182 and 6061 Dissimilar Aluminum Alloys under Different Place Configurations

Changes in the Structure and Mechanical Properties Under Heat Treatment of AlSi10Mg-Type Aluminum Alloys Obtained by Selective Laser Melting

New insight into microstructure and mechanical properties of heterostructures 7075 Al joint prepared via single mode laser welding

Experimental investigations on mechanical properties of AA6061-T6 aluminum alloy joined by laser welding using digital image correlation

Identifying the Effect of PWHT on Strength of Laser Beam Welding Joints of AA2024 Aluminum Alloy

Microstructure and High-Temperature Tensile Properties of Ti3Al Alloys Laser Welding Joint