Abstract:Improving the measurement accuracy and minimising the coupling between directions are the keys to researching the compliant six-axis force sensors. The use of a six-axis force sensor to accurately monitor the ground reaction force (GRF) and centre of pressure (COP) during human motion is of great significance in the fields of biomechanics and pathological gait diagnosis. Although complete force information can be obtained using a commercial six-axis force sensor, its high stiffness affects the natural gait and easily leads to human fatigue. A compliant six-axis force sensor based on a flexible optical waveguide is proposed, in which the force and torque of six dimensions are detected by reasonably arranging six modular sensing units, and the mechanical decoupling of some dimensions is realised in theory. For the interdimensional coupling and error caused by machining process factors, as well as the nonlinear relationship between the input and output of the proposed compliant six-axis force sensor, a DE-RBF decoupling algorithm is proposed to decouple the calibration data. Compared with the least squares method (LSM) and the radial basis function (RBF) neural network decoupling algorithm, the obtained type-I errors were reduced by 87.7629%, 43.6265%, respectively, and type-II errors by 35.3312%, 56.9162%, respectively. The decoupling result's maximum type-I and type-II errors were reduced from 7.7125% and 2.7382% in LSM and 3.1029% and 2.8917% in RBF to 0.5916% and 0.9558%, respectively. The measurement accuracy of the compliant six-axis force sensor was significantly higher; however, the time effectiveness of the proposed DE-RBF decoupling algorithm was slightly lower than that of the RBF neural network by 2.47%. In conclusion, the decoupling accuracy and timeliness of the proposed DE-RBF decoupling algorithm can satisfy the requirements of compliant six-axis force sensors to monitor low-frequency biomechanical signals, such as human motion.

Influence of flexible spherical joints parameters on accuracy of the six-axis force/torque sensor with three-three orthogonal parallel mechanism

Calibration of 6-DOF Parallel Mechanism Using Joint Force Sensors

Study on the Joint-Space Coupling Characteristics of a Generalized Load Simulator

Six-axis Force/Torque Sensor Based on Stewart Platform

An Improved Capacitive Sensor for Detecting the Micro-Clearance of Spherical Joints

The Device for Calibration Based on the Six-freedom of Generalized Force

Design and analysis of parallel six-dimensional force sensor based on near-singular characteristics

Optimizations of structure stiffnesses and sensitivities of Y-type six-axis force/torque sensor

Error Analysis of a Spherical Capacitive Sensor for the Micro-Clearance Detection in Spherical Joints

Study on the Static Stiffness of the Parallel Flexure Joint Robot

Decoupling Principle Analysis and Development of a Parallel Three-Dimensional Force Sensor

Geometric model-based joint angle selection criterion for force parameter identification & Decoupling control method of position and posture in shaft-hole assembly

Stiffness Modeling Approach for a 3-DOF Parallel Manipulator with Consideration of Nonlinear Joint Stiffness

Design and Optimization of Elastic Structure of Miniature Six-Dimensional Force/Torque Sensor

Dynamics behavior analysis of spatial parallel coordinate measuring mechanism with spherical clearance joints

A Novel Approach for Detecting Rotational Angles of a Precision Spherical Joint Based on a Capacitive Sensor

Optimization design and key-term separation identification of parallel six-dimensional pose sensor with high sensitivity and high precision

Design and Validation of Single-Axis 3D-Printed Force Sensor Based on Three Nested Flexible Rings

Structural Design and Static Calibration of Six-axis Force/Torque Sensor

Study on the Influence of Structural Parameters of Multi-Dimensional Force Sensor on Test Sensitivity

Development and Calibration of Large Deformation-Compliant Six-Axis Force Sensor