A high-entropy spinel ceramic oxide as the cathode for proton-conducting solid oxide fuel cells

Yangsen Xu,Xi Xu,Lei Bi

DOI: https://doi.org/10.1007/s40145-022-0573-7

IF: 11.534

2022-04-20

Journal of Advanced Ceramics

Abstract:Abstract A high-entropy ceramic oxide is used as the cathode for the first time for proton-conducting solid oxide fuel cells (H-SOFCs). The Fe 0.6 Mn 0.6 Co 0. 6 Ni 0.6 Cr 0.6 O 4 (FMCNC) high-entropy spinel oxide has been successfully prepared, and the in situ chemical stability test demonstrates that the FMCNC material has good stability against CO 2 . The first-principles calculation indicates that the high-entropy structure enhances the properties of the FMCNC material that surpasses their individual components, leading to lower O 2 adsorption energy for FMCNC than that for the individual components. The H-SOFC using the FMCNC cathode reaches an encouraging peak power density (PPD) of 1052 mW·cm −2 at 700 °C, which is higher than those of the H-SOFCs reported recently. Additional comparison was made between the high-entropy FMCNC cathode and the traditional Mn 1. 6 Cu 1.4 O 4 (MCO) spinel cathode without the high-entropy structure, revealing that the formation of the high-entropy material allows the enhanced protonation ability as well as the movement of the O p-band center closer to the Fermi level, thus improving the cathode catalytic activity. As a result, the high-entropy FMCNC has a much-decreased polarization resistance of 0.057 Ω·cm 2 at 700 °C, which is half of that for the traditional MCO spinel cathode without the high-entropy design. The excellent performance of the FMCNC cell indicates that the high-entropy design makes a new life for the spinel oxide as the cathode for H-SOFCs, offering a novel and promising route for the development of high-performance materials for H-SOFCs.

materials science, ceramics