Abstract:Scanning Kelvin Probe Microscopy (SKPM), a characterization method that could image surface potentials of materials at nanoscale, has extensive applications in characterizing the electric and electronic properties of metal, semiconductor and insulator materials. However, it requires deep understanding of the physics of the measuring process and being able to rule out factors that may cause artifacts to obtain accurate results.In the most commonly used dual-pass SKPM, the probe works in tapping mode to obtain surface topography information in first pass before lifting to a certain height to measure the surface potential. In this paper, we have demonstrated that the tapping-mode topography scan pass during the typical dual-pass SKPM measurement may trigger contact electrification between the probe and the sample, which leads to a charged sample surface and thus can introduce a significant error to the surface potential measurement.Contact electrification will happen when the probe enters into the repulsive force regime of tip-sample interaction and this can be detected by the phase shift of the probe vibration. In addition, the influences of scanning parameters, sample properties and probe's attributes have also been examined, in which lower free cantilever vibration amplitude, larger adhesion between the probe tip and the sample and lower cantilever spring constant of the probe are less likely to trigger contact electrification. Finally, we have put forward a guideline to rationally decouple contact electrification from surface potential measurement. They are decreasing the free amplitude, increasing the scanning amplitude, and using probes with lower spring constant.

Measurement of localized surface potential differences

Micromechanical Measurement of Active Sites on Silicon Nitride Using Surface Free Energy Variation

Quantitative measurement of the surface charge density

Intermodulation electrostatic force microscopy for imaging surface photo-voltage

Local Permittivity Measurement of Dielectric Materials Based on the Non-Contact Force Curve of Microwave Atomic Force Microscopy

A Methodology for Quantitative Evaluation of Local Electrical Conductivity: from Micron to Submicron

Measurement Method and Accumulation Characteristics of Surface Charge Distribution on Polymeric Material under DC Voltage

Measuring Double Layer Charging Via Droplet Approach Technique

Simultaneous measurement of electrical potential on both sides of the dielectric surface in a parallel-plate dielectric barrier discharges and analysis of net electric field

Excluding Contact Electrification in Surface Potential Measurement Using Scanning Kelvin Probe Microscopy.

Microscopic Four-Point Atomic Force Microscope Probe Technique for Local Electrical Conductivity Measurement

Influence of Material Surface on the Measurement of Local Electrical Conductivity Using Microwave Atomic Force Microscopy

Surface Potential Modeling and Reconstruction in Kelvin Probe Force Microscopy

Analytical Approach to the Local Contact Potential Difference on (001) Ionic Surfaces: Implications for Kelvin Probe Force Microscopy

Measurements and Calculations of Surface Charge on the Cone-Type Insulator

In-situ quantitative measurement of electric fields in zinc oxide thin films using electrostatic force microscopy

A Simple Method to Measure DC Electric Field with Space Charges

Kelvin Probe Force Microscopy and Its Application

Surface potential measurement of stress grading system of high voltage rotating machine coils using pockels field sensor

Measurement of the Surface Charging of a Plasma Actuator Using Surface DBD

Direct measurement of surface photovoltage by AC bias Kelvin probe force microscopy