Abstract:Electrical cables are one of the main fire hazards in nuclear power plants (NPPs) and in many other industrial sectors. To assess the potential damages of the cable fires, models are required to forecast the fire spread over multiple cable trays and the resulting heat release rate. A new test device, called CISCCO, was developed to conduct flame spread experiments on a preheated horizontal cable layer to support the development and validation of the models. The characteristics of the CISCCO device are first presented before the description of four series of experiments that first investigated the temperature dependence of the flame spread velocity. The series involved a cable layer composed of either a polyvinyl chloride (PVC)-based cable, named PVC cable or a halogen free flame retardant (HFFR) poly(ethylene–vinyl acetate)/polyethylene-based cable, labelled HFFR cable. Temperature measurements performed in the solid phase (cable outer sheath) and in the gas phase (above the cable layer) allowed to assess the preheated cable layer temperature and the flame spread velocity. A first attempt of flame heat flux measurements was also conducted in this work. All series highlighted a temperature dependence of the flame spread velocity according to experimental power laws. The flame spread velocities were measured higher for the PVC cable (0 to 5.5 mm/s) than for the HFFR cable (0 to 1.5 mm/s) while the related preheated cable temperatures suitable for spreading were measured lower for the former (170 to 250°C) than for the latter (280 to 370°C). Finally, one of the four test series that used the PVC cable and implemented heat release rate measurements, revealed that the cable fire growth rate is also temperature dependent according to a power law and is linearly correlated to the flame spread velocity.

Integrity Assessment of Cables Under Postulated Electrical Fire Accidents in a Zero-Power Research Reactor

An Experimental Analysis of a Nuclear-Grade Cable Based on Fire Combustion Characteristics and Pyrolysis Behavior

Failure characteristic of class 1E electrical cable used in the nuclear power plant exposed to fire

Investigating the Burning Characteristics of Electric Cables Used in the Nuclear Power Plant by Way of 3-D Transient Fds Code

Investigation of combustion, smoke, and toxicity characteristics of flame-retardant and fiber-optic cables used in nuclear power plants

Penetration Routes of Oxygen and Moisture into the Insulation of FR-EPDM Cables for Nuclear Power Plants

Numerical analysis-based structural behavior assessment of a cable-stayed bridge under tanker fire

Development of Cfd Fire Models for Deterministic Analyses of the Cable Issues in the Nuclear Power Plant

Progress in Thermohydraulic Analysis of Accident Scenarios of A Water-Cooled Fusion Demo Reactor

Application of Novel Electrical Aging Markers for Irradiated Low Voltage Nuclear Power Plant Power Cables

Preliminary Real-scale Experimental Studies on Cable Fires in Plenum

Calculation of Core Damage Frequency Caused by Main Control Board Fire in the Main Control Room for Small Modular Reactors

Reassessment of Polyethylene Power Cable

Cable tray FIRE tests simulations in open atmosphere and in confined and mechanically ventilated compartments with the CALIF3S/ISIS CFD software

Influence of Gamma Irradiation on Electric Cables Models: Study of Additive Effects by Mid-Infrared Spectroscopy

A Novel Method for Risk Assessment of Cable Fires in Utility Tunnel

Flame Spread Experiments on a Horizontal Preheated Cable Layer

A Comparative Study on Fire Hazards of Cables Used in Nuclear Power Plants Based on Small- and Large-Scale Experiments

Effect of Elevated Temperature and Internal Pressure due to Severe Accidents on the Internal Pressure Capacity of Prestressed Concrete Containment Vessel

Comparative Study on Degradation of Ethylene-Propylene Rubber for Nuclear Cables from Gamma and Beta Irradiation

Comparison of accelerated and non-accelerated post-LOCA simulation