Abstract:Abstract Changes in the measured structural responses, such as deflections and modal properties, induced by damage could be significantly smaller than those by environmental effects such as temperature and temperature gradients. To make the structural health monitoring more reliable and applicable to real structures, it is highly desirable to develop a methodology to distinguish the changes due to the structural damage from those by the environmental variations. In this study, a novel method to extract the damage-induced deflection under temperature variations is presented using the outlier analysis on the correlation of deflection components obtained using the modal flexibility matrix. The main idea is that temperature change in a bridge would produce global increase or decrease in deflections over the whole bridge. On the other hand, structural damages may cause local variations in deflections near the damage locations. Hence, the correlation analysis between the deflection measurements may show high abnormality near the damage locations. The proposed procedure may be summarized: (1) identification of the modal flexibility matrix from acceleration measurements, (2) calculation of the positive-bending-Inspection-load deflection using the modal flexibility for each damage and temperature case, (3) construction of the outlier-threshold for the correlation of the intact deflection at different locations, and (4) damage detection using the outlier analysis on the correlation of the deflection for damage cases. To verify the applicability of the proposed method, a series of laboratory tests were carried out on a bridge model with a steel box-girder. Nineteen experiments were carried out for the first 2 days under daily temperature variations to construct the correlation data for the intact deflection, and 51 experiments were performed for two damage scenarios for the next 12 days. It has been found that the damage existence and location were detected successfully for a case with relatively small damage under the temperature variations.

Online Monitoring of Flexural Damage Index of a Cable-Stayed Bridge

Vibration-Based Damage Detection Of Cable-Stayed Bridges

DAMAGE LOCATING OF CABLE-STAYED BRIDGES BASED ON DYNAMIC MEASUREMENT AND NEURAL NETWORK TECHNIQUE

Damage identification of main girders for long span cable-stayed bridge based on flexibility matrix

Structural Damage Detection of Cable-Stayed Bridges Using Changes in Cable Forces and Model Updating

Drive-by-bridge inspection for damage identification in a cable-stayed bridge: Numerical investigations

A Novel Mode Sharp-Based Damage Detection Method of Large-Span Bridges

Kalman Filter Based Estimation of Neutral Axis Position of Bridge Deck under Traffic Loading

Non-contact structural health monitoring of a cable-stayed bridge: case study

Stayed-Cable Bridge Damage Detection and Localization Based on Accelerometer Health Monitoring Measurements

Methodology of Long-Term Real-Time Condition Assessment for Existing Cable-Stayed Bridges

Damage identification in cable-stayed bridges based on the redistribution of dead and thermal loads

A multi-way data analysis approach for structural health monitoring of a cable-stayed bridge

Health monitoring of steel box girder bridges using non-contact sensors

Dynamic Assessment of Curved Cable-Stayed Bridge by Model Updating

HEALTH-MONITORING METHOD FOR BRIDGES UNDER ORDINARY TRAFFIC LOADINGS

Damage Detection of Bridge Structures Using Modal Flexibility under Temperature Variations

A strain sensor based monitoring and damage detection system for a two-span beam bridge

Dynamic Brillouin Scattering–Based Condition Assessment of Cables in Cable-Stayed Bridges

Real-time quantitative evaluation on the cable damage of cable-stayed bridges using the correlation between girder deflection and temperature

Application of a hybrid structural health monitoring approach for condition assessment of cable-stayed bridges