Abstract:Ni-based superalloy cylindrical parts widely used in the fields of aviation and aerospace have high requirements for the microstructure and mechanical properties. Hot flow spinning is an effective forming technology for manufacturing cylindrical parts with thin walls. The high-temperature plane strain compression test was put forward as the physical simulation test of hot backward flow spinning (HBFS) of cylindrical parts, and a new method for controlling the microstructure and mechanical properties of spun parts precisely based on hot processing map was proposed as the basis of selecting the reasonable processing parameters of HBSF. The results show that the relationships between the large true strains and stresses of Haynes 230 alloy during HBFS can be obtained effectively by the high-temperature plane strain compression test; the reasonable processing parameters which are beneficial for dynamic recrystallization and hot plastic deformation can be selected directly on the basis of the hot processing map. The influence of the processing parameters of HBSF on the microstructure of Haynes 230 cylindrical spun workpiece was also investigated, the results show that the influence of thinning ratio and forming temperature on the microstructure of the spun workpiece is remarkable, while the average grain size of spun workpiece decreases slightly with the increasing of feed rate. The yield strength and tensile strength of the Haynes 230 cylindrical spun part at the temperature of 800°C are both increased obviously compared with the original cylindrical blank, and the elongation is also slightly increased, which is particularly helpful in the high-temperature service of the Ni-based superalloys.

Research on Multipass Hot Spinning Process Technology of AZ80 Magnesium Alloy Shell

Research on multi-pass hot spinning based on finite element simulation and experiment for aluminum alloy component

Study on the Hot Extrusion Forming Process of AZ31 Magnesium Alloy Cylindrical Shell

Coupled Thermo-Mechanical FE Simulation of the Hot Splitting Spinning Process of Magnesium Alloy AZ31

Plasticity Improvement of Ball-Spun Magnesium Alloy Tube Based on Stress Triaxiality

Advances in Spinning of Aluminum Alloy Large-sized Thin-walled and Special-curved Surface Head

Numerical and Experimental Investigation on Hot Backward Extrusion Process of Mg-Gd-Y-Zn-Zr Magnesium Alloy

Simulation of Multi-pass Hot Rolling Process of Direct-chilled AZ31B Magnesium Alloy

Advances in Spinning of Aluminum Alloy Large-Sized Complicated Thin-Walled Shells

On optimization of Spin-Forming Process Parameters for Magnesium Alloy Wheel Hub Based on Gray Relational Analysis

Research on Precise Control of Microstructure and Mechanical Properties of Ni-based Superalloy Cylindrical Parts During Hot Backward Flow Spinning

Microstructure and Mechanical Properties of Magnesium Alloy AZ80 Wheel Fabricated by Power Spinning

Finite Element Simulation of Hot Spinning for GH4169 Superalloy Thin-Walled Shell

Numerical Simulation of Stamping-Spinning Hybrid Process for Aluminum Alloy Hemispherical Shells

Research on power spinning process of 2A12 aluminum alloy thin-walled parts

Study on the spinning process of thin-walled aluminum alloy vessel head

Numerical Simulation Study on Multi-Pass Non-Axisymmetric Spinning of Cylindrical Parts with Oblique Flange

Review on hot spinning for difficult-to-deform lightweight metals

Workability optimization and microstructure regulation for a multi-angular extrusion process of AZ80 magnesium alloy

Numerical simulation on high-speed roll casting process of magnesium alloy sheet