Abstract:International Journal of Protective Structures, Ahead of Print. Nowadays, accidental explosions in residential and factory buildings are common owing to poor maintenance and mishandling of fuel gas and chemical explosive appliances leading to grievous injuries and infrastructure damages. Contact blast on slabs using explosives is noticed as a simpler act of subversion as compared to other components of the building and is more damaging than a close-in blast. In general, damage caused by contact blast is localized in the form of concrete cratering, scabbing, and rupture of the reinforcement. A recently published state-of-the-art review on the performance of reinforced concrete (RC) slabs under contact and close-in explosion loading scenario by the authors (Anas et al., 2021b) reveals the common perception for the location of contact blast to cause maximum damage is the centroid of the slab. It develops a curiosity with sufficient interest to investigate the effect of the location of contact explosive charge on the damage response of the slab. Several numerical techniques such as empirical, ConWEP (semi-empirical), Smooth Particle Hydrodynamics (mesh-free method), and Coupled-Eulerian-Lagrangian (CEL) are in use for simulation of blast loading on structures. Current literature reveals that the CEL is the most advanced and realistic blast modeling technique. This study applies Coupled-Eulerian–Lagrangian (CEL) formulation with finite element method (FEM) using the dynamic computer code ABAQUS/Explicit-v.6.15 to investigate the performance of singly reinforced one-way spanning concrete slab subjected to concentric contact blast loading. The numerical model is validated with the experiment results in the open literature. The validated model is then employed to investigate whether or not the maximum damage is really caused by the central location of the contact blast. For this purpose, one-quarter of the slab with nine symmetrical points (or locations) of contact blast of explosive charge, which reflect the coverage of the entire slab, in contact with the top face of the slab is considered in the study. Two constitutive material models, Concrete Damage Plasticity and Johnson–Cook, with strain rate effects are used to simulate the non-linear behavior of the concrete and steel, respectively. The results reveal that the most critical location of maximum damage to the slab is along the line of symmetry parallel to the supports at an eccentricity of B/4 from the centroid of the slab, where "B" is the width of the one-way slab.

Jacketing with steel angle sections and wide battens of RC column and its influence on blast performance

Study on man-made blast disaster resistance of engineering structures

Blast performance of RC columns with different levels of concrete grades and reinforcing ratios

Experimental Evaluation of Steel Beam Bolted to Reinforced Concrete Column Connections

Performance of (1) concrete-filled double-skin steel tube with and without core concrete, and (2) concrete-filled steel tubular axially loaded composite columns under close-in blast

Numerical Analysis of Reinforced Concrete Columns Strengthened With Steel Jacket

Critical Evaluation of Vertical Stud Integration for Enhancing Blast Resistance in Slabs: A Comparative Analysis with Traditional Reinforcement Methods

Axial Loading Capacity Of Concrete-Jacketed Rc Columns With Pre- And Post-Corrosion Damage

Damage Mechanism Of Reinforced Concrete Slab Under Internal Blast Loading

Residual axial capacity of circular reinforced concrete columns subjected to contact explosions

Optimizing Reinforcement Strategies for Robust Beam-Column Joints in Seismic-Resistant Structures

Numerical study on effect of constant and variable axial loads on RC column subjected to blast load

Investigation on Damage Mechanism of RC Column under Close-in Explosion

Analytical Model for Concrete Jacketed RC Columns with Precorrosion and Postcorrosion Damages under Uniaxial Loading

The efficiency of using CFRP as a strengthening technique for reinforced concrete beams subjected to blast loading

Evaluation of critical damage location of contact blast on conventionally reinforced one-way square concrete slab applying CEL-FEM blast modeling technique

Numerical analysis of reinforced concrete buildings subjected to blast load

Experimental and numerical study on dynamic behavior of precast segmental CFDST columns under large equivalent explosions

Cyclic performance of non‐ductile reinforced concrete columns retrofitted by partial steel plate jacketing: Experiment and numerical analysis

Strengthening and Repair of Reinforced Concrete Columns by Jacketing: State-of-the-Art Review

Blast resistance of grouting sleeve connected precast concrete columns under close-in explosions