Abstract:Among four membrane distillation (MD) configurations, direct contact MD (DCMD) and vacuum MD (VMD) exhibit attractive characteristics from different perspectives and have great potential in treating reverse osmosis (RO) brine. Aiming at establishing a quick approach to predict the key output parameters associated with MD module performance and process efficiency, Aspen plus was employed to conduct systematic evaluation for both DCMD and VMD. Due to the lack of built-in MD operation models in Aspen Plus, one dimensional transport models were developed and complied as user customized units to simulate the hollow fiber-based DCMD and VMD modules. The corresponding programming was coded in FORTRAN language. The mathematical models for DCMD and VMD were verified by comparing the simulations results with the experimental and literature data, respectively.By incorporating the boundary-layer effect into the newly-established transport models, steady-state simulations of the respective DCMD and VMD flowsheets were carried out. The results showed that the DCMD presented much lower process efficiency than VMD in terms of permeation flux and specific energy consumption per kg distillate generated, even though it is considered as the simplest and most commonly employed configuration. With the same module specifications and operating conditions at equivalent energy cost, the VMD system demonstrated a minimal 2.5-fold higher average vapor flux (e.g., water recovery capacity) when compared to DCMD. The fundamental difference between the two configurations was revealed through MD mass- and heat-transfer analysis. Based on simulated temperature profiles, it was found that the VMD configuration presented a much higher driving force (transmembrane temperature difference) and negligible conductive heat loss to the membrane, which is a promising feature for achieving high thermal efficiency.

Mass transfer mechanism of reverse osmosis concentrate brines with vacuum membrane distillation in arid areas

Modeling of the Variations of Permeate Flux, Concentration Polarization, and Solute Rejection in Nanofiltration System

Unlocking the Potential of Thin-Film Composite Reverse Osmosis Membrane Performance: Insights from Mass Transfer Modeling

Modeling mass transfer using surface morphology in full-scale reverse osmosis membrane processes

Research on simulation of desalination of NaCl aqueous solution by vacuum membrane distillation

Mass transfer in hollow fiber vacuum membrane distillation process based on membrane structure

Simulation of the Transport Phenomenon Occurring in Membrane Pores During Vacuum Membrane Distillation

Simulation and Experimental Investigation of the Vacuum-Enhanced Direct Membrane Distillation Driven by a Low-Grade Heat Source

Confined mass transfer mechanism and preparation strategies of separation membranes: A review

Simulation and calculation of membrane parameters in vacuum membrane distillation

Evaluation of Commercial PTFE Membranes for Desalination of Brine Water Through Vacuum Membrane Distillation

Studies of Affecting Factors on the Process of Vacuum Membrane Distillation

Mass Transfer Model of Permeating Molecules in Pervaporation Membrane

Exploring Mass Transfer Mechanisms in Reverse Osmosis Membranes: A Comparative Study of SDM and DSPM-DE Models

A Method for Experimental Determination of Mass Transfer Resistance Across Membrane in Vmd

Mechanisms and models for water transport in reverse osmosis membranes: history, critical assessment, and recent developments

Evaluation of Hollow Fiber-Based Direct Contact and Vacuum Membrane Distillation Systems Using Aspen Process Simulation

Research Progress of Mass Transfer Models for Pervaporation

Analysis of Concentration Polarisation in Full-Size Spiral Wound Reverse Osmosis Membranes Using Computational Fluid Dynamics

Modeling of heat and mass transfer in vacuum membrane distillation for seawater desalination

Conjugate heat and mass transfer in vacuum membrane distillation for solution regeneration using hollow fiber membranes