Intelligent Management of Chemical Warehouses with RFID Systems

Jumin Zhao,Fangfang Xue,Deng-ao Li

DOI: https://doi.org/10.3390/s20010123

IF: 3.9

2019-12-24

Sensors

Abstract:At present, most chemical warehouses rely on human management, which is a time-consuming and laborious process. Therefore, it is very meaningful to use radio frequency identification (RFID) systems for the intelligent management of chemicals. Detecting the remaining amount of chemicals is an important process in the management of a chemical warehouse. It helps managers find the chemicals that are going to run out and replenish them in time. However, in a traditional chemical warehouse, managers usually inspect each chemical on the shelf in turn manually, which is a waste of time and labor. Although some solutions using RFID technology have been proposed, they are expensive and difficult to deploy in a real environment. In order to solve this problem, we propose an intelligent system called the RF-Detector in this paper, which combines robotics and RFID technology. An RFID reader and an antenna are installed on the robot, which achieves automatic scanning of the chemicals. The RF-Detector can achieve two functions: One function is to detect the remaining amount of chemicals using the changes in received signal strength indication (RSSI) and read rate, and the other is to locate chemicals using the phase curve, so that managers can quickly find the chemicals with an insufficient amount remaining. In this paper we implement the RF-Detector and evaluate its performance. The experimental results show that the RF-Detector achieves about 93% detection accuracy and 92% positioning accuracy for chemicals.

engineering, electrical & electronic,chemistry, analytical,instruments & instrumentation

What problem does this paper attempt to address?

This paper attempts to solve two main problems in chemical warehouse management:

1. **Detecting the remaining amount of chemicals**: In traditional chemical warehouses, managers need to manually check the remaining amount of chemicals in each container, which is a time - consuming and labor - intensive process. Through observation, it is found that Received Signal Strength Indicator (RSSI) and read rate can be used as indicators to judge the remaining amount of chemicals. When the chemicals are insufficient, the RSSI value and read rate will change. The paper proposes a method that combines RSSI and read rate, and uses the Support Vector Machine (SVM) algorithm to distinguish which chemicals are about to be depleted and which are still sufficient.

2. **Locating the position of chemicals**: In addition to detecting the remaining amount of chemicals, it is also necessary to determine the specific location of the chemicals that are about to be depleted so that managers can replenish them in a timely manner. The paper proposes a method of using the phase curve of the tag for positioning. By processing the periodic jumps of the phase curve, it is converted into a continuous super - phase curve, and then the position of the tag is determined by fitting the super - phase curve. Specifically, through the establishment of a coordinate system and relevant formula derivation, the exact position of the tag can finally be obtained.

### Main contributions

1. **Combining RFID technology and robotics technology**: The RF - Detector system is proposed, which can automatically scan chemicals, reduce manual intervention, and improve efficiency.
2. **Detecting the remaining amount of chemicals**: By combining RSSI and read rate, a detection accuracy rate of 93% is achieved.
3. **Locating the position of chemicals**: By processing the phase curve, a positioning accuracy rate of 92% is achieved, helping managers quickly and accurately find the chemicals that need to be replenished.

### Experimental verification

The paper verifies the performance of the RF - Detector system through experiments. The experimental results show that the RF - Detector performs well in detecting the remaining amount of chemicals and locating the position of chemicals, achieving the expected results. Specific experiments include:

- **Detecting the remaining amount of chemicals**: Through multiple experiments, the relationship between the changes of RSSI and read rate and the remaining amount of chemicals is verified, and the results are as expected.
- **Locating the position of chemicals**: By simulating a simple chemical warehouse scenario, the effectiveness of the phase curve processing and fitting method is verified, and the positioning accuracy rate reaches 92%.

In conclusion, this paper proposes an intelligent management system based on RFID and robotics technology, which effectively solves two major problems in chemical warehouse management.