Finite Element Analysis of Needle Insertion Angle in Insulin Therapy

Syakirah Mohamed Amin,Muhammad Hanif Ramlee,Hadafi Fitri Mohd Latip,Gan Hong Seng,Mohammed Rafiq Abdul Kadir
DOI: https://doi.org/10.15282/ijame.16.4.2019.21.0555
2019-12-30
International Journal of Automotive and Mechanical Engineering
Abstract:Millions in the world suffering diabetes mellitus depends on insulin therapy to control their blood glucose level daily. However, the painful daily injections they need to take could lead to other complications if it is not done correctly. To date, it is suggested by many researchers and medical doctors that the needles should be inserted at any angles of 90o or 45o. Nevertheless, this recommendation has not been supported by clinical or biomechanical evaluation. Hence, this study evaluates the needle insertion for insulin therapy to find the favourable angles in order to reduce injury and pain onto the skin. Finite element analysis was done by simulating the injection of three-dimensional (3D) needle model into a 3D skin model. The insertions were simulated at two different angles, which are 45oand 90o with two different lengths of needles; 4 mm and 6 mm. This study concluded the favourable angle for 4 mm needle to be 90o while 6 mm needle was best to be inserted at 45o as these angles exerted the least maximum stress and strain onto the skin.
What problem does this paper attempt to address?