Abstract:Improved power output and energy density have been achieved in piezoelectric transducers by exploiting ferroelectric/ferroelastic switching. However, a problem is that stable working cycles with polarization switching normally cannot be driven by stress alone. This problem has been addressed by using internal bias fields in a partially poled ferroelectric: the material state is engineered such that compressive stress drives ferroelastic switching during mechanical loading, while residual fields restore the polarized state during unloading. However, although this method has been verified, the devices in engineering material states with the best performance haven't been explored systematically. In this work, internal bias fields in a partially poled (pre-poled) ferroelectric are used to guide polarization switching, producing an effective energy harvesting cycle. Devices are tested and optimized in the frequency range 1-20Hz, and the influence of the degree of pre-poling in the fabrication process on energy harvesting performance is explored systematically. It is found that pre-poling the ferroelectric ceramic to about 25% of the fully poled state results in a device that can generate a power density up to about 26 mW/cm 3 of active material at 20Hz, an improvement on prior work and an order of magnitude advance over conventional piezoelectrics. However, maximizing the power density can result in residual stresses that risk damage to the device during preparation or in service. The relationship between fabrication success rate and pre-poling level is studied, indicating that greater degrees of pre-poling correlate with higher survival rate. This provides a basis for balancing energy conversion with device robustness.

Investigation on energy dissipation by polarization switching in ferroelectric materials and the feasibility of its application in sound wave absorption

Stress induced polarization switching and coupled hysteretic dynamics in ferroelectric materials

Vibration Energy Harvesting Based on Stress-Induced Polarization Switching: a Phase Field Approach

Hysteretic Dynamics of Ferroelectric Materials under Electro-Mechanical Loadings

Modeling of Nonlinear Responses for Reciprocal Transducers Involving Polarization Switching

Modeling of the Stress-Dependent Hysteretic Dynamics of Ferroelectric Materials

Extension of the Landau Theory for Hysteretic Electric Dynamics in Ferroelectric Ceramics

Research Progress in Polarization Switching of Ferroelectric Materials

Three-dimensional finite element modeling of polarization switching in a ferroelectric single domain with an impermeable notch

Phase-field Simulations of Ferroelectric/ferroelastic Polarization Switching

A micro-electro-mechanical model for polarization switching of ferroelectric materials

Phase field modeling of dielectric breakdown of ferroelectric polymers subjected to mechanical and electrical loadings

In-situ Acoustical Investigation of the Polarization Build-Up in Cellular Polypropylene Ferroelectrets

Duality of Switching Mechanisms and Transient Negative Capacitance in Improper Ferroelectrics

Energy harvesting using ferroelectric/ferroelastic switching: the effect of pre-poling

Study on the Polarization and Relaxation Processes of Ferroelectric Polymer Films Using the Sawyer–Tower Circuit with Square Voltage Waveform

The Electric Fatigue and Thermal Effect for Ferroelectric Materials under Cyclic Electric Loading

In-situ acoustical monitoring of the effective-polarization hysteresis in cellular polypropylene ferroelectrets

Probing phonon softening in ferroelectrics by the scanning probe microwave spectroscopy

Dual mechanisms for transient capacitance anomaly in improper ferroelectrics

Polarization Fatigue in Ferroelectrics:Fundamentals and Recent Developments