Development of technology of preparation of pork semi-products with the application of low-temperature treatment

M. F. Khairullin,E. A. Koval,I. Y. Levitskaya,M. G. Gadjiev,B. A. Sultonov
DOI: https://doi.org/10.20914/2310-1202-2019-2-250-256
2019-11-01
Proceedings of the Voronezh State University of Engineering Technologies
Abstract:The study was aimed at developing a technology for preparing various semi-finished products from pork meat using low-temperature processing "Su-Vid". The main physicochemical indicators, functional-technological and structural-mechanical characteristics of semi-finished products, the chemical composition of semi-finished products and finished products were identified and determined experimentally, and organoleptic analysis was carried out. The data indicate that the use of low-temperature processing significantly affects the characteristics of manufactured products, which improves its performance. In particular, pork semi-finished products prepared at low temperatures are characterized by the yield: steak – 93.9%, ribs – 92.6%, in comparison with the control regime, 7.5 and 6.2% higher. The complex of data obtained showed that the samples of semi-finished pork, according to the experimental regimes of heat treatment, in terms of safety, fully meet the requirements of TR TS 034/2013. Analysis of semi-finished pork products showed that products prepared using the Su-Vid technology had high organoleptic characteristics, taste and sensory characteristics. During the storage of semi-finished products, minor changes in proteins and fats, as well as organoleptic, sanitary and microbiological characteristics, took place. As a result, a bone steak was developed in the Caucasian marinade and pork ribs in the Monte Ritz marinade made using the Su-Vid technology. The results allow us to judge that this technology is quite promising and has a positive effect on the characteristics of manufactured products. The widespread introduction of this technology in the meat industry will allow the development of semi-finished products and products of high quality, nutritional and biological value compared to products manufactured by traditional methods, as well as reduce production costs.
What problem does this paper attempt to address?