Abstract:Hyper-redundant continuum manipulators present dexterous kinematic skills in complicated tasks and demonstrate promising potential in underground exploration, intra-cavity inspection, surgery, etc. However, the hyper-redundancy, which endows much dexterity and flexibility, brings a huge challenge to the kinematics solution and control of the continuum manipulators. Due to the pseudoinverse calculation of high-order Jacobian matrix or iteration, many inverse kinematic solution approaches of continuum manipulators are very time-consuming, which extremely limit their applicability in real-time control. Additionally, it is often difficult for the manipulators to perform the tasks well in complex scenarios due to lack of human intervention. Therefore, in this paper, a simplified kinematics model of a typical hyper-redundant manipulator is proposed based on its unique geometry relationships, where the mapping relationships between the actuators’ rotation and the end-effector’s position are derived through the analysis of its driving subsystem and motion subsystem, in particular the joint modules. To perform the tasks of manipulators with the help of operators, a teleoperation control scheme with modified wave transmission structure is designed to achieve the guaranteed stability and improved transparency, and the leader’s trajectory and generated force feedback are the transmitted signals in the communication channel. Specifically, a virtual force feedback generation algorithm is developed in the teleoperation control scheme via the processing tracking errors, which can improve the operators’ assistance and perception during the teleoperation process. The practical experiments with comparative wave variable structures in two different sets are implemented to verify the effectiveness of proposed kinematics model and control scheme.

Variable Impedance Control of Cable Actuated Continuum Manipulators

Coordinated variable impedance control for multi-segment cable-driven continuum manipulators

Finite-Time Observer-Based Variable Impedance Control of Cable-Driven Continuum Manipulators

Analysis and Validation of a Flexible Limb/Cable Hybrid-Driven Parallel Continuum Manipulator

A Variable-Cross-Sectional Continuum Manipulator Capable of Grasping by Whole-Arm Wrapping

An Optimized Cable Layout Method for Cable-Driven Continuum Robots

Compliant Control Technology of Manipulator

Dynamic Modeling and Experimental Verification of a Cable-Driven Continuum Manipulator with Cable-Constrained Synchronous Rotating Mechanisms

Teleoperation Control Design with Virtual Force Feedback for the Cable-Driven Hyper-Redundant Continuum Manipulator

Workspace Analysis of Cable-driven Continuum Manipulator with Cable-constrained Synchronous Rotating Mechanism

Quasi-static modeling of a cable-driven continuum manipulator considering non-smooth cable-hole friction and experimental verification

Hybrid Tension-Position Control of Cable-Driven Serial Manipulator to Improve Accuracy and Avoid Cable Slack and Breakage

Dynamic control with tension compensation of a 3-DOF cable-driven parallel manipulator

Investigation on the Multi-Solution Problem of the Kinetostatics of Cable-Driven Continuum Manipulators

Fuzzy-based variable impedance control of uncertain robot manipulator in the flexible environment: A nonlinear force contact model-based approach

Tension Optimization of a Cable-Driven Coupling Manipulator Based on Robot Dynamics with Cable Elasticity.

Kinetostatics for Variable Cross-Section Continuum Manipulators

Statics of Continuum Space Manipulators with Nonconstant Curvature Via Pseudorigid-Body 3R Model

A Closed-Loop Controller for Cable-Driven Hyper-Redundant Manipulator with Joint Angle Sensors.

Development of a linear decoupling cable-driven manipulator with independent driving joints ,

An Adaptive Impedance Control for Dual-Arm Manipulators Incorporated with the Virtual Decomposition Control