Abstract:Reverse engineering technology has been widely recognized as a crucial strategy for innovative design of products. However, currently one of major problems for its application is that huge amounts of digitized points cloud data need to be processed for geometrical surface modelling, especially for unknown free-form surfaces which are widely used in industry fields such as aircraft, automobile, shipbuilding, steam turbine, etc. In order to digitize unknown free-form surfaces accurately and efficiently, an adaptive sampling approach based on advanced path detecting has been presented. The method is characterized by integrating one touch- trigger probe and two laser probes onto the same Z axis of Coordinate Measuring Machine (CMM), and the two laser probes are located on both sides of the touch probe. During sampling, the CMM scans the free-form surface line by line. At the scanning direction, the laser probes are applied to collect the measuring path information in front of the touch probe. And the data acquired by the laser probes is processed and fitted into B-spline curves real-timely, and then the curvature feature of the measuring path is extracted. The obtained path information is used to generate a new measuring path for touch probe to achieve adaptive sampling. While at the cross-section feeding direction, curvature analysis algorithm based on the angle variation between measuring sections is employed to subdivide the cross-sections when needed. Repeating this procedure, the measuring sections will be distributed adaptively. Simulation and experiment results indicate that the sampling points generated by the touch probe are laid out rationally according to the curvature of the surfaces, therefore the sampling efficiency and accuracy can be improved significantly by the proposed approach.

A novel 3D radius compensation method of probe stylus tip in the free-form surface profile curve scanning measurement

An Adaptive Sampling Approach for Digitizing Unknown Free-form Surfaces Based on Advanced Path Detecting

Digitalization of Unknown Free-Form Surface Based on Variable-Direction Point Laser Sensor

A Study on Free Form Surface Digitization Based on Ultrasonic Distance Measurement

Non-contact adaptive sampling for unknown free-form surface based on double-probe integration

Misalignment Correction for Free-Form Surface in Non-Null Interferometric Testing

Error Correction Of Laser Scanning System For Reverse Engineering

A Stitching Linear-Scan Method for Roundness Measurement of Small Cylinders

Error Compensation Based on Surface Reconstruction for Industrial Robot on Two-Dimensional Manifold.

A Novel Method for Analyzing the Influence of Relative Attitude of Laser Profile Scanner on 3D Measurement System

Non-equidistant Scanning Path Generation for the Evaluation of Surface Curvature in Metrological Scanning Probe Microscopes

A New Centering Method of the Measuring Probe for Spiral Scanning-Based Surface Profile Measurement Systems

Nonlinear Analysis and Dynamic Compensation of Stylus Scanning Measurement with Wide Range

A Novel Method of Efficient Machining Error Compensation Based on Nurbs Surface Control Points Reconstruction

Error Compensation of Free-Form Surface with Critical Area Based on T-spline Surface Reconstruction.

Full Area Covered 3D Profile Measurement of Special-Shaped Optics Based on a New Prototype Non-Contact Profiler.

Touch-Trigger Probe Error Compensation for Nonvertical On-Machine Measurement of Freeform Surface Workpieces

A dual-probe three-dimensional profile measurement system

Extrinsic calibration method for 3D scanning system with four coplanar laser profilers

Profile Measurements of Micro-Aspheric Surfaces Using an Air-Bearing Stylus with A Microprobe

Accurate Inner Profile Measurement of a High Aspect Ratio Aspheric Workpiece Using a Two-Probe Measuring System