Abstract:Abstract Hydraulic fracturing has remained a fundamental technique for stimulation of oil and gas reservoirs for enhanced or economic recovery of hydrocarbons from tight formations for more than 60 years. Transporting proppant downhole without any interruption and then to obtain maximum recovery of fracturing fluids are two important criteria for successful hydraulic fracturing. To achieve such objectives, the fracturing fluid should demonstrate good viscosity and complete cleanup of gelling agents. Because wells are exploited at both shallow and great depths in environments of moderate to very high temperatures and pressures, fracturing fluid selection is fundamental. Fracturing fluids prepared by crosslinking guar, guar derivatives, and other naturally occurring polymers with borate or metal crosslinkers often exhibit instability at very high temperatures. The primary reason for instability of the fracturing fluid is because strength of the bonds between the polymer chain and crosslinker decreases sharply in addition to breakdown of the glycosidic bonds between monomer units of the polymer chain beyond 375°F. Additionally, metal crosslinked bonds are prone to shear degradation, creating doubt for a successful stimulation treatment in high-temperature extended-reach wells. To address these issues, a synthetic gelling-agent-based fracturing fluid that can work at temperatures greater than 400°F was developed. The gelling agent is a terpolymer, which can be crosslinked with a zirconium-based crosslinker. This paper discusses evaluation and performance of an extreme temperature fracturing fluid. This fracturing fluid system has sufficient proppant carrying viscosity and provides efficient post-treatment cleanup using delayed oxidized breaker. Analysis of fluid viscosity stability and delayed oxidizing breaker usage is presented in addition to performance parameters such as regained permeability and fluid loss. The study illustrates performance of the synthetic gelling-agent-based fracturing fluid at temperatures ranging from 380 to 440°F.

Tertiary cross-linked and weighted fracturing fluid enables fracture stimulations in ultra high pressure and temperature reservoir

High Temperature Resistance and Low-Cost Fracturing Fluid System

Modified guanidine gel fracturing fluid system and performance optimization for ultra-deep and ultra-high temperature oil and gas reservoirs

Synthetic polymer fracturing fluid weighted by sodium formate enables fracture stimulations in Ultra-High pressure and High-Temperature reservoir

Development and evaluation of a novel high-density weighted fracturing fluid in ultra-deep reservoirs

Development and Field Application of a New Ultralow Guar Gum Concentration Weighted Fracturing Fluid in HPHT Reservoirs

Experimental Study on Novel High Density and High Temperature Tolerant Fracturing Fluid

Evaluation of Fracturing Fluid for Extreme Temperature Applications

Performance Evaluation of High Temperature Fracturing Fluid

Experimental Investigation and Performance Evaluation of a Novel High Temperature Tolerant Seawater-based Fracturing Fluid

Study of Fracturing Fluid on Gel Breaking Performance and Damage to fracture conductivity

A new type of high density fracturing fluid system

Ultra-deep reservoirs gel fracturing fluid with stepwise reinforcement network from supramolecular force to chemical crosslinking

Fast Hydrating Fracturing Fluid for Ultrahigh Temperature Reservoirs

Research on Calcium Chloride Weighted Polymer Fracturing Fluid for Ultra Deep and High Stress Reservoirs

Doubly cross‐linked polymer gels with ultra‐high‐thermal stability for hydrofracking

Research Progress of High Temperature Resistant Fracturing Fluid System

Synthesis and evaluation of salt tolerant delayed-crosslinking fracturing fluid system in ultra-deep high temperature wells