Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

Effects of stress paths on triaxial compression mechanical properties of QH-E lunar soil simulant studied by DEM simulation

Triaxial Compression Tests of QH-E Lunar Soil Simulant under Constant Mean Principal Stress Path Using Discrete Element Method Simulations

Experimental research and discrete element analysis of shear strength of lunar soil simulants

Techniques for triaxial compression tests on simulant lunar soil QH-E and its mechanical behaviors under low confining stress

DEM analysis of the dynamic characteristics of QH-E lunar soil simulant under cyclic triaxial tests

Stress path triaxial tests onK0-consolidated saturated soft clay

BEHAVIOR OF PORE WATER PRESSURE IN DYNAMIC TRIAXIAL TESTS OF SATURATED SOFT CLAY AND ITS EFFECT ON EFFECTIVE STRESS PATH

Mechanical Properties of QH-E Lunar Soil Simulant at Low Confining Stresses

Influence Of Stress Path On Secant Modulus Of Soft Saturated Clay

DISCRETE ELEMENT MODELING OF STRENGTH PROPERTIES AND FAILURE MODES OF QH-E LUNAR SOIL SIMULANT AT LOW CONFINING STRESSES

Intact soft clay’s critical response to dynamic stress paths on different combinations of principal stress orientation

Effects of principal stress rotation and cyclic confining pressure on behavior of soft clay with different frequencies

Influences of Stress Magnitude and Loading Frequency on Cyclic Behavior of K0-consolidated Marine Clay Involving Principal Stress Rotation

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

Undrained Dynamic Behaviors of Saturated Clays under Compressive Stress Paths Considering Cyclic Confining Pressure

Cyclic Deformation Behaviour of Natural K 0 -Consolidated Soft Clay under Different Stress Paths

Experimental Study of Silty Clay Plane Strain Tri-axial Test under RTC Path and Modified Cam-clay Model

Undrained Cyclic Triaxial Behavior of Saturated Clays under Variable Confining Pressure

Effect of Anisotropic Consolidation Stress Paths on the Undrained Shear Behavior of Reconstituted Wenzhou Clay

Stiffness Degradation and Plastic Strain Accumulation of Clay under Cyclic Load with Principal Stress Rotation and Deviatoric Stress Variation

Study of Mechanics Behavior and Constitutive Model of Cemented Soil under Static Triaxial Tests