Optimization of proppant parameters for CBM extraction using hydrofracturing by orthogonal experimental process

Haoze Li,Bingxiang Huang,Qingying Cheng,Xinglong Zhao

DOI: https://doi.org/10.1093/jge/gxaa009

2020-03-13

Journal of Geophysics and Engineering

Abstract:Abstract Proppant placement concentration, particle size and creep time are important factors that affect the embedment of proppant into coal. Based on multistage creep, an orthogonal test is conducted, and an optimal proppant scheme for different closure stresses obtained. The results show that with increased proppant placement concentration, the number of coal fractures increases and the elastic modulus of the fracture area decreases. As the proppant particle size decreases, the plasticity of fracture-proppant assemblies increases gradually. The yield limit is highest when the particle size is 20/40 mesh. During the proppant embedding process, localization or uneven distribution of proppant results in tensile stress parallel to the fracture surface, which induces tensile fracture in the coal. In the fracture-proppant assembly areas, proppant fractures are severe and yield lines appear. As proppant concentration increases, more energy is accumulated during the proppant compaction stage, resulting in energy release producing craters and crevasses. The energy released also causes increased stress in the proppant-coal contact area and fracturing to the coal mass. The longer the creep time, the weaker the impact and the smaller is fluctuation. Moreover, we find that the orthogonal test can effectively analyze the importance of each parameter. Proppant placement concentration was found to have the highest influence on the process of proppant embedding into coal, followed by particle size and then time. Under experimental conditions, the lowest proppant-embedded value in coal samples was observed with proppant placement concentration of 2 kg m−2 and particle size of 20/40 mesh.

geochemistry & geophysics