Abstract:Vehicle scanning methods are gaining popularity because of their ability to identify modal properties of several bridges with only one instrumentation setup, and several methods have been proposed in the last decade. In the numerical models used to develop and validate such methods, bridge damping is often overlooked, and its impact on the efficacy of vehicle scanning methods remains unknown. The present article addresses this knowledge gap by systematically investigating the effects of bridge damping on the efficacy of vehicle scanning methods in identifying the modal properties of bridges. For this, acceleration responses obtained from a numerical model of a bridge and vehicle are used. Four different scenarios are considered where vehicle damping, presence of road roughness, and traffic on the bridge are varied. Bridge damping is modeled using mass-proportional, stiffness-proportional, and Rayleigh damping models. The impacts of ignoring bridge damping or considering one of these damping models on the modal frequencies and mode shapes identified using the vehicle response are investigated by comparing the results. The outcomes of the numerical analysis show that ignoring bridge damping in vehicle scanning applications can significantly increase the efficacy of these methods. They also show that the identifiability of the bridge frequencies and bridge mode shapes from the vehicle response decreases significantly when bridge damping is considered. Further, the damping model used impacts which bridge modes can be identified because different damping models provide different modal damping ratios for each mode. The results highlight the importance of correctly simulating damping behavior of bridges, which is often ignored, to be able to correctly evaluate the efficacy of vehicle scanning methods, and they provide an important stepping stone for future studies in this field.

Additional damping effect on bridges because of vehicle-bridge interaction

Energy-based additional damping on bridges to account for vehicle-bridge interaction

FEM analysis of vehicle-bridge vibration considering bridge deck's vibration

Damping Parameter Identification Of Large Span Cable-Stayed Bridges

A Modified Bridge System method to characterize and decouple vehicle–bridge interaction

MDOF extension of the Modified Bridge System method for vehicle–bridge interaction

Simulation Vibration Analysis of Train and Railway Continuous Steel Truss Bridge

A simplified method to assess vehicle–bridge interaction for train-induced vibration of light-weight railway bridges

Numerical analysis of vehicle-bridge coupling vibration concerning nonlinear stress-dependent damping

Optimal Tuning of Inerter–Spring–Damper Vehicle Suspension for Mitigation of Bridge Response

Passive and Adaptive Damping Systems for Vibration Mitigation and Increased Fatigue Service Life of a Tied Arch Railway Bridge

Dynamic Analysis and Optimization of Vehicle-Bridge Interaction System under Road Roughness and Time Variability of Element Interpolation Function

A vehicle-bridge interaction vibration model considering bridge deck pavement

A vehicle-bridge interaction model considering contact patch size and vehicle self-generated excitation – A theoretical study

Effect of Damping on the Identification of Bridge Properties Using Vehicle Scanning Methods

Dynamic Response Impact of Vehicle Braking on Simply Supported Beam Bridges with Corrugated Steel Webs Based on Vehicle-Bridge Coupled Vibration Analysis

Extended Modified Bridge System (EMBS) method for decoupling seismic vehicle‐bridge interaction

The influence of vehicle dynamics on the time-dependent resonances of a bridge

Effect of Elastomeric Bearing Stiffness on the Dynamic Response of Railway Bridges Considering Vehicle–Bridge Interaction

Comparison of Different Modeling Approaches and Their Influence on the Dynamic Calculation of Four Single-Span Railway Bridges

An analysis method of vehicle–bridge coupling vibration considering effects of expansion joint parameters and its application