Abstract:This work presents a hydrothermal-based facile method for synthesizing ZnFe 2 O 4, whose size can be controlled with the concentration of sodium acetate used as a fuel and its physical changes at nanoscales when exposed to two different gases. The structural, morphological, compositional, and electronic properties of the synthesized samples are also presented in this paper. The crystal structure of the synthesized samples was determined using an X-ray Diffractometer (XRD). The results revealed fluctuations in the size, lattice parameter, and strain in the nanoparticles with increasing the concentration of sodium acetate. Field-Emission Scanning Electron Microscopy (FESEM) was used to determine synthesized materials' morphology and particle size. It revealed that the particles possessed approximately spherical morphology whose size decreased significantly with the increasing amount of sodium acetate. Transmission Electron Microscopy (TEM) was utilized to determine the structure, morphology, and elemental distributions in particles at the nanoscale, and it confirmed the findings of XRD and FESEM analyses. The high-resolution TEM (HRTEM) imaging analysis of the nanoparticles in our studied samples revealed that the particles predominantly possessed (001) type facets. X-ray photoelectron spectroscopy (XPS) and core-loss electron energy loss spectroscopy (EELS) showed an increasing fraction of Fe 2+ with the decreasing size of the particles in samples. The Brunauer, Emmett, and Tellers (BET) analysis of samples revealed a higher surface area as the particle size decreases. In addition, the determined surface area and pore size values are compared with the literature, and it was found that the synthesized materials are promising for gas-sensing applications. The ab initio calculations of the Density of States (DOS) and Band structure of (001) surface terminating ZnFe 2 O 4 were carried out using Quantum Espresso software to determine the bandgap of the synthesized samples. They were compared to their corresponding experimentally determined bandgap values and showed close agreement. Finally, in-situ TEM measurement was carried out on one of the four studied samples with robust properties using Ar and CO 2 as reference and target gases, respectively. It is concluded from the presented study that the size reduction of the ZnFe 2 O 4 nanoparticles (NPs) tunes the bandgap and provides more active sites due to a higher concentration of oxygen vacancies. The in-situ TEM showed us a nanoscale observation of the change in one of the crystal structure parameters. The d spacing of ZnFe 2 O 4 NPs showed a noticeable fluctuation, reaching more than 5% upon exposure to CO 2 and Ar gases.

XRD characterization of Fe3O4-ZnO nanocomposite material by the hydrothermal method

Detailed investigation of the structural and electrical properties of ZnO/Fe 3 O 4 nanocomposites

Synthesis and Characterisation of Transition Metal Iron Oxide Nanocomposite Crystals and Particles Using Wet Chemical Coprecipitation Method

Characterization of structural and spectroscopic properties of ZnO/Fe2O3 nanocomposites

High-temperature Solid State Synthesis and Characterization in Magnetic and Transporting Properties of Zn_xFe_(3-x)O_4 Powder

Synthesis and Characterization of Fe-doped Hydroxyapatite/ZnO Nanocomposites Using the Coprecipitation Method from Processed Limestone

SONOCHEMICAL SYNTHESIS AND MICROSTRUCTURE CHARACTERIZATION OF Fe3O4 AND ZnFe2O4 NANOCRYSTALLINES

Optimization of structure, optical, magnetic, and radiation shielding properties of ZnO@xSrFe 12 O 19 nanocomposites

Znfe2o4 Nanoparticles Prepared Using the Hydrothermal and the Sol-Gel Methods

Preparation of Composite Nanoparticles of Fe-Zn Bioxide Using Surface Modification and Their Subsequent Characterization

Spin dynamics investigations of multifunctional ambient scalable Fe3O4 surface decorated ZnO magnetic nanocomposite using FMR

Synthesis, Characterizations, and Applications of Fe3O4 and Co-Doped Fe3O4 Nanomaterials

Synthesis, characterization, and preliminary insights of ZnFe2O4 nanoparticles into potential applications, with a focus on gas sensing

Facile fabrication of ZnO nanorods modified Fe3O4 nanoparticles with enhanced magnetic, photoelectrochemical and photocatalytic properties

Synthesis and characterization of thermo-sensitive magnetite-Au nanocomposites

Synthesis and characterization of ZnO–NiO binary nanocomposites by hydrothermal technique for gas sensing and photocatalytic applications

Facile Synthesis and Characterization of ZnFe2O4/α-Fe2O3 Composite Hollow Nanospheres

Investigation of the iron doping on the structural, optical, and magnetic properties of Fe-doped ZnO nanoparticles synthesized by sol–gel method

Structure, morphology, optical and magnetic studies of Fe3O4-doped CdS nanocomposite

Preparation and characterization of Fe3O4 nanoparticles via a hydrothermal process with propanediol as the solvent

Synthesis and characterization of nanocrystallite ZnCrFeO4