Determination of fiber saturation point of rattan (Calamus simplicifolius) using the LF-NMR and two conventional methods

Limei Yang,Genlin Tian,Shumin Yang,Lili Shang,Xing’e Liu,Zehui Jiang

DOI: https://doi.org/10.1007/s00226-020-01177-2

2020-04-21

Wood Science and Technology

Abstract:Abstract Water exists in lignocellulosic materials throughout the whole process from the plant growth to raw materials processing and utilization. The fiber saturation point (FSP) is the inflection point of the physical and mechanical properties of lignocellulosic materials and has an important influence on their physical and mechanical properties. This paper investigates the FSP of Calamus simplicifolius by the low-field nuclear magnetic resonance (LF-NMR) method and two conventional methods including the saturated salt solution method and dynamic vapor sorption (DVS) method. The average FSP values determined by the LF-NMR method, the saturated salt solution method and the DVS method are 38.15%, 32.54% and 28.96%, respectively. The study showed that the FSP values determined by the LF-NMR method were higher than those determined by the two conventional methods. The two conventional methods are simple and cost-effective and are able to directly measure whether the rattan properties are changing with moisture content. From the thermodynamics standpoint, even within the ideal solution limit, free water is present at relative humidity (RH) of less than 100%. Therefore, extrapolation to 100% RH was not strictly correct. The amount of water in rattan in different states could be quantified by the LF-NMR method, and the FSP value was determined by the ratio of the measurements above and below the water melting point. Furthermore, the LF-NMR method is faster and non-destructive compared to the two conventional methods.

materials science, paper & wood,forestry