Abstract:This thesis describes Near Infrared (NIR) initiated photopolymerization of multifunctional acrylic esters with NIR-LEDs emitting between 750 – 870 nm. These systems comprise a zwitterionic cyanine as sensitizer and an iodonium salt with distinct substitution pattern in both the cation and anion. An optically open window from the UV into the visible part allows embedding of functional materials covering particular this spectral range. Reactivity was studied with a synchronized photo-DSC comprising a self-designed hardware setup for data acquisition. 28 new iodonium salts ([A-I-B]+X-) were studied to show the influence of structural pattern on reactivity. [A-I-B]+X- possesses a different substitution pattern for the cation and the anion, respectively. Electron transfer of the excited state of the polymethine to the iodonium cation bearing different anions such as benzilate, lactate, NO3-, PF6-, SbF6-, p-CH2=CH-Ph-SO3-, p-C12H15-Ph-SO3-, CF3SO3-, C4F9SO3-, B(CN)4-, B(Ph)4-, B(PhF5)4-, N(CN)2- or (SO2-CF3)2N- results in initiating radicals. Although most of these anions do not participate in the redox mechanism, there exists a certain dependence between reactivity and the nature of the anion. Anions with low coordination behavior ((SO2-CF3)2N-, B(Ph)4-,B(PhF5)4-, B(CN)4-) result in acceptable reactivity. This may be explained by the conductivity of the salt in the acrylate monomers such as hexane-1,6-diol diacrylate, tripropylene glycol diacrylate, poly(ethylene glycol) diacrylate and trimethylolpropane triacrylate being different. A high ion mobility leads connects always to a high conductivity. Thus, complete dissociation is necessary to obtain a reactive system. The solubility of the different iodonium salts covers several g/L up to well mixable systems (>2000 g/L). A good solubility is not mandatory to obtain a high reactivity but it is desirable from a practical point of view. Particular the bis(trifluoromethylsulfonyl) imide anion (N(SO2-CF3)2-) results in giant solubilities depending on the iodonium cation. Such photoinitiating systems are interesting because they bleach at the excitation wavelength and open therefore the opportunity to cure coatings with large thickness; that is a length up to several millimeters (14 mm). In addition, NIR-exposure additionally results in formation of light-stable brownish photoproducts. This represents an interesting alternative compared to brownish pigments used in dental materials. These findings require to understand the mechanism of sensitizer decomposition in more detail applying exposure kinetics and a coupling of Ultra Performance Liquid Chromatography (UPLC) with mass spectrometry (MS) to analyze the photoproducts formed. Data show unexpected cleavage of the polymethine chain at typical positions in case of the oxidized species. These were formed as a result of electron transfer between the excited state of the photosensitizer and the iodonium salt. UPLC-MS experiments additionally indicated a certain sensitivity of the system upon adding of acids and radicals generated by thermal decomposition of AIBN. Thus, treatment of the photoinitiator composition (sensitizer and iodonium salt) with either radical or proton forming agents led almost to the same products no matter the system was either exposed with NIR light or not. Futhermore, photo-initiated crosslinking of multifunctional acrylic esters in polymeric binders was investigated based on digital imaging using the Computer-to-Plate (CtP) technology applying laser exposure in the NIR at 830 nm. Iodonium salts derived from several borates and those with the bis(trifluoromethylsulfonyl) imide anion resulted in lithographic materials with high sensitivity being comparable with those used in industrial systems. Finally, iodonium salts comprising the bis(trifluoromethylsulfonyl) imide anion exhibit a lower cytotoxicity compared to those with the tetraphenyl borate anion as determined by the MTT-test using CHO-9-cells.

NIR‐Sensitized Activated Photoreaction between Cyanines and Oxime Esters: Free‐Radical Photopolymerization

Naphthoquinone-imidazolyl derivatives-based oxime esters as photoinitiators for blue LED-induced free radical photopolymerization

Naphthoquinone-Based Oxime Esters for Free Radical Photopolymerization under Sunlight or a Blue Light-Emitting Diode

Photoinitiating Ability of Pyrene‐Chalcone‐based Oxime Esters with Different Substituents

Phenylthioether thiophene-based oxime esters as novel photoinitiators for free radical photopolymerization under LED irradiation wavelength exposure

Naphthalene-Based Oxime Esters as Type I Photoinitiators for Free Radical Photopolymerization

Multibranched triarylamine end-capped oxime esters as visible-light absorbing Type I photoinitiators for free radical photopolymerization

Near‐Infrared Emission Beyond 900 Nm from Stable Radicals in Nonconjugated Poly(diphenylmethane)

Efficient Visible Photoinitiator With High-Spectrum Stability In An Acid Medium For Free-Radical And Free-Radical-Promoted Cationic Photopolymerization Based On Erythrosine B Derivatives

Photoinitiation Mechanisms of Novel Phenothiazine‐Based Oxime and Oxime Esters Acting as Visible Light Sensitive Type I and Multicomponent Photoinitiators

Synthesis of Carbazole-Chalcone Bis-Oxime Esters (CCBOEs) as Blue Light Photoinitiators of Polymerization

Carbazole-fused coumarin based oxime esters (OXEs): efficient photoinitiators for sunlight driven free radical photopolymerization

Study on the photoinitiation mechanism of carbazole-based oxime esters (OXEs) as novel photoinitiators for free radical photopolymerization under near UV/visible-light irradiation exposure and the application of 3D printing

Photoinitiation behavior of phenothiazines containing two oxime ester functionalities (OXEs) in free radical photopolymerization and 3D printing application

Untersuchungen zur NIR-sensibilisierten radikalischen Photopolymerisation in multifunktionellen Monomeren

Enhanced One/Two‐Photon Initiating Performance of Nitro‐Carbazole‐Styrene Based Oxime/Ketoxime Esters

A Pyrrole–Carbazole Photoinitiator for Radical and Cationic Visible Light LED Photopolymerization

Effect of the Steric Hindrance and Branched Substituents on Visible Phenylamine Oxime Ester Photoinitiators: Photopolymerization Kinetics Investigation through Photo‐DSC Experiments

Penta-Methine Cyanine IRTs: Enabling NIR or Visible Photoinduced Polymerization of Acrylate and Thiol–Ene for Preparation of Polychromatic and Color-Changing Polymers

Pyrrole-based enone dyes as radical photointiator under 405/460 nm LED lamp: The effect of ketone structure

The Blue‐LED‐Sensitive Naphthoquinone‐Imidazolyl Derivatives as Type II Photoinitiators of Free Radical Photopolymerization