Abstract:For structural health monitoring of large bridges,the traditional manual detection is inadequate because of its strong subjectivity,bad entirety and bad timeliness.The widely used wired health monitoring system also has some problems in the actual applications.For example,it is hard to wire in some area and it is easy to be affected by environment.Using wireless sensor networks in bridge structural health monitoring not only retains the advantage of wired health monitoring system but also makes up for its deficiencies in the applications.The paper describes the composition of the whole system,and discusses the composition of wireless sensor nodes in the monitoring area of the system.Through studying the composition of base station,the paper gives the role of base station in the health monitoring system.On the basis of the composition of wireless sensor nodes,the paper addresses the mean value drift of the accelerometer output resulting from temperature changes.It gives a method to calibrate the output value of using temperature compensation technology.In order to verify this method,we give a comparison between uncorrected accelerometer readings and corrected accelerometer readings.Then,through proposing the necessity of time synchronization of all nodes before data collection,the paper discusses the principle of time synchronization.At last,we built a health monitoring system which was composed by data collection,data transmission,data reception and data analysis.And we tested the system in the anchor cable of Runyang Yangtze River Bridge.We installed the wireless sensor node in the anchor cable and obtained its vibration information through accelerometer.Then these data was sent to the base station,and to monitoring center in final.By analyzing these data,the vibration frequency spectrum of anchor cables could be obtained.Through analyzing the frequency,the strength of bridge's cables would be figured out.It is useful to identify if the bridge is in a healthy status.If the data deviates from the normal range,the monitoring center will respond in time.At last,the paper gives a conclusion that the wireless system is suitable for bridge structural health monitoring field and useful for actual application.

Monitoring of varadhi road bridge using accelerometer sensor

Bridge health monitoring system based on vibration measurements

Using Drive-by Health Monitoring to Detect Bridge Damage Considering Environmental and Operational Effects

Review of Vibration-Based Damage Detection and Condition Assessment of Bridge Structures Using Structural Health Monitoring

Bridge Safety Monitoring Using IoT

IoT based bridge monitoring system

Healthy monitoring and altering system on-line of bridge structures Ⅰ——Design for monitoring assessment,altering system and modules

Performance Monitoring of the Geumdang Bridge Using A Dense Network of High-Resolution Wireless Sensors

Comparative study on sensitivity of acceleration and strain responses for bridge health monitoring

Design and Validation of an Accurate Low-Cost Data Acquisition System for Structural Health Monitoring of a Pedestrian Bridge

Health monitoring system of steel-tube arch bridge : design and implementation of a teaching demonstration platform

Monitoring bearing damage in bridges using accelerations from a fleet of vehicles, without prior bridge or vehicle information

Development of Smart Sensing Technology Approaches in Structural Health Monitoring of Bridge Structures

Using limited roving sensors to monitor bridge subjected to random traffic load

A Real-Time Bridge Scouring Monitoring System Based on Accelerometer Sensors

An Innovative Sensor Integrated with GNSS and Accelerometer for Bridge Health Monitoring

A new method for bridge structural health monitoring based on wireless sensor networks

Development and field evaluation of a low-cost bridge bearing movement monitoring system

Low-Cost Wireless Structural Health Monitoring of Bridges

Advancement of bridge health monitoring using magnetostrictive sensor with machine learning techniques