Emission of Oxygenated Polycyclic Aromatic Hydrocarbons from Indoor Solid Fuel Combustion
Guofeng Shen,Shu Tao,Wei Wang,Yifeng Yang,Junnan Ding,Miao Xue,Yujia Min,Chen Zhu,Huizhong Shen,Wei Li,Bin Wang,Rong Wang,Wentao Wang,Xilong Wang,Armistead G. Russell
DOI: https://doi.org/10.1021/es104364t
IF: 11.4
2011-01-01
Environmental Science & Technology
Abstract:Indoor solid fuel combustion is a dominant source of polycydic aromatic hydrocarbons (PAHs) and oxygenated PAHs (OPAHs) and the latter are believed to be more toxic than the former. However, there is limited quantitative information on the emissions of OPAHs from solid fuel combustion. In this study, emission factors of OPAHs (EFOPAH) for nine commonly used crop residues and five coals burnt in typical residential stoves widely used in rural China were measured under simulated kitchen conditions. The total EFOPAH ranged from 2.8 +/- 0.2 to 8.1 +/- 2.2 mg/kg for tested crop residues and from 0.043 to 71 mg/kg for various coals and 9-fluorenone was the most abundant specie. The EFOPAH for indoor crop residue burning were 1-2 orders of magnitude higher than those from open burning, and they were affected by fuel properties and combustion conditions, like moisture and combustion efficiency. For both crop residues and coals, significantly positive correlations were found between EFs for the individual OPAHs and the parent PAHs. An oxygenation rate, R-o, was defined as the ratio of the EFs between the oxygenated and parent PAR species to describe the formation potential of OPAHs. For the studied OPAH/PAH pairs, mean R-o values were 0.16-0.89 for crop residues and 0.03-0.25 for coals. R-o for crop residues burned in the cooking stove were much higher than those for open burning and much lower than those in ambient air, indicating the influence of secondary formation of OPAH and loss of PAHs. In comparison with parent PAHs, OPAHs showed a higher tendency to be associated with particulate matter (PM), especially fine PM, and the dominate size ranges were 0.7-2.1 mu m for crop residues and high caking coals and < 0.7 mu m for the tested low caking briquettes.