Abstract:The need for wireless communication has driven the communication systems to high performance. However, the main bottleneck that affects the communication capability is the Fast Fourier Transform (FFT), which is the core of most modulators. This paper presents FPGA implementation of pipeline digit-slicing multiplier-less radix 22 DIF (Decimation In Frequency) SDF (single path delay feedback) butterfly for FFT structure. The approach is taken, in order to reduce computation complexity in butterfly multiplier, the digit-slicing multiplier-less technique was utilized in the critical path of pipeline Radix-22 DIF SDF FFT structure. The proposed design focused on the trade-off between the speed and active silicon area for the chip implementation. The multiplier input data was sliced into four blocks each one with four bits to process at the same time in parallel. The new architecture was investigated and simulated with MATLAB software. The Verilog HDL code in Xilinx ISE environment was derived to describe the FFT Butterfly functionality and was downloaded to Virtex II FPGA board. Consequently, the Virtex-II FG456 Proto board was used to implement and test the design on the real hardware. As a result, from the findings, the synthesis report indicates the maximum clock frequency of 555.75 MHz with the total equivalent gate count of 32,146 is a marked and significant improvement over Radix 22 DIF SDF FFT butterfly. In comparison with the conventional butterfly architecture design which can only run at a maximum clock frequency of 200.102 MHz and the conventional multiplier can only run at a maximum clock frequency of 221.140 MHz, the proposed system exhibits better results.

Design and Implementation of MIPS Processor for LU Decomposition based on FPGA

Vlsi Implementation of A High-Performance 32-Bit Risc Microprocessor

Design of 16 Bit RISC Processor and Implementation using MIPS Technique

Design of RISCV processor using verilog

Design and Implementation of 32-Bit Integral Microprocessor Based on FPGA

Parallel Sparse LU Decomposition Using FPGA with an Efficient Cache Architecture.

Design and Implement of RISC Microprocessor Based on FPGA

A multi-FPGA based platform for emulating a 100m-transistor-scale processor with high-speed peripherals (abstract only)

Instruction Decompressor Design for a VLIW Processor

Design, development and testing of a 16-bit reduced instruction set computer architecture based processor

An Implementation of a Dual-Processor System on FPGA

Efficient Hardware Design and Implementation of Encrypted MIPS Processor

ASIC Design and Implementation of 32 Bit Arithmetic and Logic Unit

Design of an SoC Based on 32-Bit RISC-V Processor with Low-Latency Lightweight Cryptographic Cores in FPGA

Study on Design and Extension of a FPGA-based 16 Bit Microprocessor

A Design and Implementation of Radix-4 Based Fast Multiplier on FPGA

FPGA Implementation of pipeline Digit-Slicing Multiplier-Less Radix 2 power of 2 DIF SDF Butterfly for Fourier Transform Structure

FPGA implementation for solving linear least square problem

Simulation and Design of MIPS Processor Based on VLSI Platform

VLSI Implementation of a 32bit Embedded Reduced-Instruction-set-computer

Efficient VLSI Design and Implementation of an Elliptic Curve Cryptography Processor