Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Mathematical Modeling and Simulation of Development of the Fires in Confined Spaces

Development of a Mathematical Model of Fire Spreading in a Three-Storey Building Under Full-Scale Fire-Response Tests

MATHEMATICAL MODELING OF FIRE DEVELOPMENT IN A THREE-STOREY RESIDENTIAL BUILDING DURING FULL-SCALE FIRE TESTS

Study On Simulation Of The Building Fires Using An Advanced New Model

Pool Fires Within a Large Under-Ventilated Environment: Experimental Analysis and Numerical Simulation Using OpenFOAM

Capabilities and Limitations of the Fire Dynamics Simulator in the Simulation of Tunnel Fires with a Multiscale Approach

Simulation of tunnel fire with roof opening

3D Numerical Simulation of Smoke Flow in Long Tunnel Fires

Smoke Diffusion in Transverse Passageway of High-Rise Building Fires

Simulation Framework for Structural Safety in Building Fire

Numerical Simulation of Multistory Building Fire with Zone—modeling Method

The GIS-based Simulation of Urban Mass Fire Spread

Numerical Simulation of Smoke Control in Underground Space

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Numerical Simulation of Asphalt Pavement Temperature Distribution in Long Tunnel Fires

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

Numerical Simulation of the Fire Smoke Flow in the Corridor of a Building

Numerical Simulation of Fire Spread in a Large-Scale Open CLT Compartment

Computer simulation development of smoke diffusing and control in fires of high-rise buildings

Numerical Simulation of Fire in Underground Commercial Street

Physically-based Model for Fire Scenario in FDS