Comparative analysis on the effect of 1-decanol and di-n-butyl ether as additive with diesel/LDPE blends in compression ignition engine

Rajesh Adhinarayanan,Aravindh Ramakrishnan,Gopal Kaliyaperumal,MelvinVíctor De Poures,Rajesh Kumar Babu,Damodharan Dillikannan

DOI: https://doi.org/10.1080/15567036.2020.1773967

2020-06-05

Abstract:The present study utilizes (a) recycled low density polyethylene oil extracted through catalytic pyrolysis and (b) 1-decanol and di-n-butyl ether, as a blend component with diesel to power a single-cylinder, light-duty, water-cooled, four-stroke, common rail direct injection diesel engine. Experiments were conducted with two ternary blends and they were designated as (1) D70L20D10 (2) D70L20DNBE10. Later these results were compared with baseline diesel and D70L30 blend. Results indicated that replacing 10% by vol. of LDPE oil in D70L30 blend with 1-decanol and di-n-butyl ether was beneficial in increasing the combustion characteristics of the research engine, ignition delay period of oxygenated blends got shorter when compared to D70L30 blend. Slightly higher peak pressures were observed with the ternary blends than baseline fuels. Brake thermal efficiency of diesel was high at part load, whereas at peak load, D70L20DNBE10 shown 0.7% and 3.1% superior performance than diesel and D70L30 blend respectively. NOx emission for D70L20D10 and D70L20DNBE10 blend was found lower by 17.9% and 5.7% respectively than the D70L30 blend. Smoke opacity of the ternary blend was found to be lower against D70L30 and higher with diesel operations. The study revealed that 1-decanol and di-n-butyl ether could be a potential fuel additives for diesel engines operating with LDPE oil extracted from LDPE plastic waste.