Abstract:Selectivity is the key parameter in industrial ethylene oxide (EO) production by oxidation of ethylene with oxygen on Ag/α–Al2O3 catalysts. Accurate temperature control in wall-cooled multitubular fixed-bed reactors and chlorination of the silver surface by feeding small chlorinated hydrocarbons such as 1,2-dichloroethane (DCE) are required to fine-tune electrophilicity and surface oxygen coverage for maximum EO selectivity at economic ethylene conversion. Temperature and molar flow rate profiles of C2H4, O2, EO, CO2, H2O, DCE, and chlorine-containing reaction products vinyl chloride (VC) and ethyl chloride (EC) were measured in a compact profile reactor (CPR) and in a pilot-scale profile reactor (PSPR) to explore the spatial interplay between DCE concentration, temperature, inlet flow rate, and O2 conversion. Chlorine and oxygen compete for the same active silver sites despite more than 4 orders of magnitude different concentrations (ppm vs vol %). Chlorine coverage increases from inlet to outlet due to the decreasing partial pressure of O2 along the bed, leading to shutdown of all reactions if all active Ag sites are blocked by chlorine. A kinetic model is derived from a dual-site mechanism taken from the literature. Kinetic parameters are determined from differential initial rate measurements, Arrhenius plots, and by fitting the rate expressions implemented in a plug flow model to the species and temperature profiles in the CPR. A very good agreement is reached. PSPR profiles are modeled by implementing the derived kinetic model into a 2D pseudohomogeneous reactor model. At conversions <10%, the experimental profiles are well captured, but the model fails to accurately reproduce the point of thermal runaway in the catalyst bed of the PSPR caused by a too low reactor temperature and resulting insufficient chlorine coverage of the silver surface.

Chloride-mediated selective electrosynthesis of ethylene and propylene oxides at high current density

Preferential Adsorption of Ethylene Oxide on Fe and Chlorine on Ni Enabled Scalable Electrosynthesis of Ethylene Chlorohydrin

Electrifying Oxidation of Ethylene and Propylene

Redox-mediated electrosynthesis of ethylene oxide from CO2 and water

Selective Oxidation of Ethylene to Ethylene Oxide on Silver Catalysts at Industrial Conditions: Reactor Profiles, Kinetics, and Chlorine Inhibition

Highly selective synthesis of propylene glycol ether from methanol and propylene oxide catalyzed by basic ionic liquid

Studies on ethylene oxychlorination II. Reaction mechanism and kinetics

Ethylene Electrooxidation to 2-Chloroethanol in Acidic Seawater with Natural Chloride Participation

Spatial decoupling of bromide-mediated process boosts propylene oxide electrosynthesis

Ethylene Oxide Catalysis Under Commercial Conditions – A Guide for Researchers

Atomistic Insights into Cl–-Triggered Highly Selective Ethylene Electrochemical Oxidation to Epoxide on RuO2: Unexpected Role of the in Situ Generated Intermediate to Achieve Active Site Isolation

Catalytic Hydroxyethylation of Phenols with Renewable Ethylene Glycol Diester As an Alternative to Ethylene Oxide

Selective production of ethylene glycol at high rate via cascade catalysis

Direct electrochemical propylene epoxidation driven by water-activation intermediates

Atomically Asymmetrical Ir–O–Co Sites Enable Efficient Chloride‐mediated Ethylene Electrooxidation in Neutral Seawater

Constraining CO coverage on copper promotes high-efficiency ethylene electroproduction

HClO‐Mediated Photoelectrochemical Epoxidation of Alkenes with Near 100% Conversion Rate and Selectivity by Regulating Lattice Chlorine Cycle

Electrochemical Synthesis of Dimethyl Carbonate from Methanol, CO2 and Propylene Oxide in an Ionic Liquid

Chloride-mediated electrochemical synthesis of oxazolines

Efficient Ethylene Electrosynthesis Through C–O Cleavage Promoted by Water Dissociation

Upgrading Ethylene Via Renewable Energy-Driven Electrocatalysis