Abstract:Electrochemical CO2 reduction enables the conversion of intermittent renewable energy to value-added chemicals and fuel, presenting a promising strategy to relieve CO2 emission and achieve clean energy storage. In this work, we developed nanosized Cu2O catalysts using the hydrothermal method for electrochemical CO2 reduction to alcohols. Cu2O nanoparticles (NPs) of various morphologies that were enclosed with different crystal facets, named as Cu2O-c (cubic structure with (100) facets), Cu2O-o (octahedron structure with (111) facets), Cu2O-t (truncated octahedron structure with both (100) and (111) facets), and Cu2O-u (urchin-like structure with (100), (220), and (222) facets), were prepared by regulating the content of a polyvinyl pyrrolidone (PVP) template. The electrochemical CO2 reduction performance of the different Cu2O NPs was evaluated in the CO2-saturated 0.5 M KHCO3 electrolyte. The as-synthesized Cu2O nanostructures were capable of reducing CO2 to produce alcohols including methanol, ethanol, and isopropanol. The alcohol selectivity of the different Cu2O NPs followed the order of Cu2O-t < Cu2O-u < Cu2O-c < Cu2O-o (with the total Faradaic efficiencies of alcohol products of 10.7, 25.0, 26.2, and 35.4%). The facet-dependent effects were associated with the varied concentrations of oxygen-vacancy defects, different energy barriers of CO2 reduction, and distinct Cu–O bond lengths over the different crystal facets. The desired Cu2O-o catalyst exhibited good reduction activity with the highest partial current density of 0.51 mA/cm2 for alcohols. The Faradaic efficiencies of alcohol products were 4.9% for methanol, 17.9% for ethanol, and 12.6% for isopropanol. The good electrochemical CO2 reduction performance was also associated with the surface reconstruction of Cu2O, which endowed the catalyst with abundant Cu0 and Cu+ sites for promoted CO2 activation and stabilized CO* adsorption for enhanced C–C coupling. This work will provide a new route for enhancing the alcohol selectivity of nanostructured Cu2O catalysts by crystal facet engineering.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c03850.DFT calculation methods, procedures for catalyst synthesis, experimental setup, HRTEM images and SAED patterns, cyclic voltammetry curves for calculating double-layer capacitors, LSV and CV curves of the catalysts tested in the N2-saturated 0.5 M KHCO3 electrolyte, Tafel plots of the different catalysts, fitting results of the EIS data to the equivalent circuit for the different catalysts, structure of the different facets and side and top views of the facets after CO2 adsorption, CV curves of the different catalysts tested in N2- and CO2-saturated 0.5 M KHCO3 electrolytes, XPS analysis of Cu2O-o before and after testing in the presence of N2 and CO2, and chronoamperometric i–t curves of the Cu2O-o tested under varied applied potentials (PDF)This article has not yet been cited by other publications.

Preparation of FTO/CU2O Electrode Protected by PEDOT:PSS and Its Better Performance in the Photoelectrocatalytic Reduction of CO2 to Methanol

Effect of Cu(BDC-NH2) MOF deposited on Cu/Cu2O electrode and its better performance in photoelectrocatalytic reduction of CO2

Photoelectrocatalytic Reduction of CO2 to CO via Cu2O/C/PTFE Nanowires Photocathodes

CuFeO 2 /CuInS 2 Composite Thin Film Photocathode Prepared by Template Method for CO 2 Conversion Into Methanol

Controllable preparation of Cu2O/Cu-CuTCPP MOF heterojunction for enhanced electrocatalytic CO2 reduction to C2H4

Photoelectrochemical Reduction of Carbon Dioxide with a Copper Graphitic Carbon Nitride Photocathode.

Stable Aqueous Photoelectrochemical CO2 Reduction by a Cu2O Dark Cathode with Improved Selectivity for Carbonaceous Products

Efficient Cu 2 O Photocathodes for Aqueous Photoelectrochemical CO 2 Reduction to Formate and Syngas

MOF-derived Cu@Cu2O Heterogeneous Electrocatalyst with Moderate Intermediates Adsorption for Highly Selective Reduction of CO2 to Methanol

Electro-reduced copper on polymeric C3N4 for photocatalytic reduction of CO2

Highly Efficient Photoelectrocatalytic Reduction of CO2 to Methanol by a p–n Heterojunction CeO2/CuO/Cu Catalyst

Metal-Organic Framework Coating Enhances the Performance of Cu2O in Photoelectrochemical CO2 Reduction.

Copper‐Decorated Microsized Nanoporous Titanium Dioxide Photocatalysts for Carbon Dioxide Reduction by Water

Preparation of Fe2O3-TiO2 and Its Photocatalytic Reduction of CO2 to Methanol

Efficient Cu<sub>2</sub>O Photocathodes for Aqueous Photoelectrochemical CO<sub>2</sub> Reduction to Formate and Syngas

Constructing Cu0/Cu+ interfaces on Cu-based MOFs derivatives to promote the adsorption stability of intermediates in the process of CO2 electroreduction to C2 products

Investigation and mitigation of degradation mechanisms in Cu2O photoelectrodes for CO2 reduction to ethylene

Promoting hydrophilic cupric oxide electrochemical carbon dioxide reduction to methanol via interfacial engineering modulation

Synthesis of Cu 2 O Nanostructures with Tunable Crystal Facets for Electrochemical CO 2 Reduction to Alcohols

Highly Stable Layered Coordination Polymer Electrocatalyst Towards Efficient CO 2 ‐to‐CH 4 Conversion

A low overpotential photoelectrochemical reduction of carbon dioxide to methanol with highly photoactive hierarchical structured cuprous oxide