Abstract:Tiltrotors permit aircrafts to operate vertically with lift, yet convert to ordinary forward flight with thrust. The challenge is to design a tiltrotor blade yielding maximum lift and thrust that converts smoothly without losing integrity or efficiency. The two types of blades, soft in-plane and stiff in-plane—the designation depending on the value of the blade's natural lag frequency—exhibit different structural responses under the same flight conditions, differently affecting the aerodynamics of the blades, especially in the complex aerodynamic environment of conversion flight where the aerodynamic differences are significant. This phase of flight is not deeply researched, nor is the analytical coupling method much used. To study the influence of blade type on aerodynamics during conversion, models suitable for the conversion flight simulation are established for the application of coupled computational fluid dynamics and computational structural dynamics (CFD-CSD) methods. Each method is implemented with well-accepted techniques (the Unsteady Reynolds-Averaged Navier–Stokes (URANS) equations, the Reverse Overset Assembly Technique (ROAT), and the Timoshenko beam model. To improve the solving efficiency, a loose coupling strategy is used in constructing the two-way coupled model. The XV-15 tiltrotor is used for verification. The aeroelastic simulation of soft in-plane and stiff in-plane blades in conversion flight indicates an impactful role on the modal shapes, with a significant difference in the third flap modal shapes for the XV-15 rotor. However, the effect on aerodynamic performance is relatively small. In the first half of the flight conversion, the thrust of stiff in-plane blades is larger than that of soft in-plane blades, but in the last half, the influence of structural characteristics on aerodynamic performance is negligible and the thrust of the blades tends to be equal.

Coupled CFD/MBD Method for a Tilt Tri-rotor UAV in Conversion of Flight Modes

Unsteady Flow Simulation of a Variable-Sweep Morphing Aircraft Coupled with Flight Control System

Multiobjective Shape Optimization of A Hypersonic Lifting Body Using A Correlation-Based Transition Model

Dynamic Modeling and Control for Tilt-Rotor UAV Based on 3D Flow Field Transient CFD

Numerical simulation of the transition flight aerodynamics of cross-shaped quad-tiltrotor UAV

Modeling and Simulation for Multi-Rotor Fixed-Wing UAV Based on Multibody Dynamics

Large-Sized Multirotor Design: Accurate Modeling with Aerodynamics and Optimization for Rotor Tilt Angle

Automated Design Optimization of a Mono Tiltrotor in Hovering and Cruising States

Coupled Flexible and Flight Dynamics Modeling and Simulation of a Full-Wing Solar-Powered Unmanned Aerial Vehicle

Aerodynamic Simulation of a Typical Multirotor e VTOL Aircraft Configuration.

Numerical Simulation on Aerodynamic Characteristics of Transition Section of Tilt-Wing Aircraft

Conversion control of a tilt tri-rotor unmanned aerial vehicle with modeling uncertainty

Comparative Study of Soft In-Plane and Stiff In-Plane Tiltrotor Blade Aerodynamics in Conversion Flight, Using CFD-CSD Coupling Approach

Modeling and control of a class of urban air mobility tiltrotor aircraft

Investigations on Trimming Strategy and Unsteady Aerodynamic Characteristics of Tiltrotor in Conversion Procedure

MECHANICAL MODELLING OF A MULTI-LAYER PARALLEL PRE-COMPRESSED MFC BIMORPH MORPHING WING

A Coupled Helicopter Rotor/Fuselage Dynamics Model Using Finite Element Multi-body

Multiple Modeling and Fuzzy Switching Control of Fixed-Wing VTOL Tilt-Rotor UAV

Conceptual design and flight test of two wingtip-docked multi-body aircraft

Dynamic Modeling of Quadrotor AUV Using a Novel CFD Simulation

A Study on the Aerodynamic Impact of Rotors on Fixed Wings During the Transition Phase in Compound-Wing UAVs